Think Tank Photo Belly Dancer User manual

Belly Dancer
1www.thinktankphoto.com
This image demonstrates the proper fit of
the Belly Dancer.
Step 1: Belt should be unbuckled. Hold
Belly Dancer in front of you, keeping the
crossed shoulder straps near your body as
shown above.
Step 2: Place your arms inside the outer
straps, while holding the crossed portion
at the top, as shown above.
Step 3: Bring crossed portion of shoulder
straps over your head.
Step 4: Allow shoulder straps to hang on
shoulders.
Step 5: Connect the belt buckle in the
back.
Step 6: Adjust belt to fit properly around your
waist.
Step 7: Adjust front harness straps to
minimize any slack.
Step 8: Adjust back harness straps to
keep top of straps in desired location.

Belly Dancer may be used with Camera
Support Straps shown above.
Step 1: Attachment clip will securely snap
onto the front of the Shoulder Harness.
Supporting Camera on Front Straps of Belly Dancer:
Modulus components can be attached
to the Belly Dancer Belt as shown
above.
Rotate: To “Rotate” modular components
around the belt, place the white plastic
divider behind the belt before securing the
connection.
Attaching Modulus and Skin Components to Belly Dancer:
Lock: To “Lock” modular components in
position, insert the white plastic dividers
into the outside rail of the belt.
2www.thinktankphoto.com
When using the Camera Support Straps, please note: If sufficient weight is not applied to
the back of the belt, or if the belt is not tight enough, the front of the harness may pull
backward due to lack of counter weight for your camera.