THOR ZONE Booster Cell User manual

USER MANUAL (ENG)
BOOSTER CELL
THOR ZONE

1BOOSTER CELL
S:t Persgatan 23, 602 33 Norrköping Sweden
[email protected] thor-zone.com
THOR ZONE
BC LINK
8X M3x44X M3x18
SCREWS
BOOSTER CELL
WHAT’S IN THE BOX?

2BOOSTER CELL
S:t Persgatan 23, 602 33 Norrköping Sweden
[email protected] thor-zone.com
THOR ZONE
1. Remove the original front cap and the grills
INSTRUCTIONS
SCREWS
•Hex key (size: H2.0)
TOOLS
INSTALL BOOSTER CELL — SHELL (1/2)

3BOOSTER CELL
S:t Persgatan 23, 602 33 Norrköping Sweden
[email protected] thor-zone.com
THOR ZONE
2. Align the Booster Cell to the Shell NOTE: Rotate Booster Cell by 180° if you are using flipped layout
3. Secure both of them to each other using 2x short grills
INSTRUCTIONS
SCREWS
•Hex key (size: H2.0)
TOOLS
INSTALL BOOSTER CELL — SHELL (2/2)

4BOOSTER CELL
S:t Persgatan 23, 602 33 Norrköping Sweden
[email protected] thor-zone.com
THOR ZONE
OUT
POWER OR RESET SWITCH
PWM FAN HEADER
1. Remove the original storage frames and screws
2. Attach the BC Link to the Core and secure it with two M3x4 screws
3. Connect the BC Link 2-pin connector (Booster Cell front button) NOTE: Configure as either a power button or reset switch
4. Connect the BC Link 4-pin connector to a fan header on your motherboard
•Connect the BC Link 3-pin connector to one of the OUT-ports on your LED strips NOTE: MJOLNIR R ONLY
INSTRUCTIONS
2x M3x4
SCREWS
•Hex key (size: H2.0)
TOOLS
INSTALL BOOSTER CELL — CORE

5MJOLNIR
S:t Persgatan 23, 602 33 Norrköping Sweden
[email protected] thor-zone.com
THOR ZONE
1. Attach a slim 120mm PWM fan to the Booster Cell and secure it using four M3x18 screws
2. Connect 4-pin PWM fan connector to the Booster Cell
INSTRUCTIONS
4x M3x18
SCREWS
•Hex key (size: H2.0)
TOOLS
ADD 120MM FAN