TiGHT AV AU-X2O-DA User manual

DANTE 2CH XLR OUTPUT ADAPTER
User Manual
AU-X2O-DA
DANTE 2CH XLR OUTPUT
ADAPTER
All Rights Reserved
Version: AU-X2O-DA_2022V1.0
Product Introduction
Thanks for choosing the AU-X2O-DA.
The device outputs 2 channels of
analog line level audio from your
Dante network, supporting sampling
rates up to 96kHz, using Audinate’s
original Dante Ultimo chip.
Features
Plug and Play
Dante and AES67 support
24-bit audio support
0X2 audio channels
Supports 802.3af PoE
Packing List
1x AU-X2O-DA
1x User Manual
Panel Description
①RJ45: Dante network
communication port.
Green steady light indicates link;
yellow flashing light indicates data
traffic. The green light will flash to
identify the device when clicking
the Dante Controller “Identify”
button (an eye-shaped symbol) on
the host computer
②XLR: 2 x XLR-M connectors, for
output signal
Customer Service
We provide limited warranty for the
product within five years counting
from date of purchase (The purchase
invoice shall prevail).
Note: Please contact your distributor
immediately if any damage or defect in the
device is found.

DANTE 2CH XLR OUTPUT ADAPTER
Technical Specification
Audio
Max signal level
+18 dBu / +4
dBu / 0 dBu
0 dBV /-10 dBV
Frequency
Response
20Hz to 20kHz
(-/+0.5dB)
Impedance
150 Ohm
balanced
75 Ohm
unbalanced
Dynamic Range >100 dB
Signal to Noise
Ratio
>100 dB
THD
<0.01% @+4
dBu
Dante
Sample Rate
44.1kHz,
48kHz, 96kHz
Bit Depth 24
Dante Device
Latency
1, 2 or 5ms
(configurable
using Dante
Controller)
Network
Transport
Dante Audio
over IP
AES67 RTP
Model Name AU-X2O-DA
General
Operation
Temperature
-5 to +55 (+23°
to +131°F)
Storage
Temperature
-25 to +70℃
(-13° to +158°F)
Power 802.3af PoE
Power
Consumption
2.6W (Max)
Dimension
(W*H*D)
30 x 28 x 114
mm
Cable length
300mm
Net Weight
145g
Compliance
FCC, CE
Environmental
RoHs, WEEE