
TIKI® BRAND FIRE PIT
9
Can I control the flame height?
The Wood Pack is designed to maintain a
full and consistent flame for approximately
30 minutes. If you desire more control over the
flame size you can use wood logs and add more
or less based on preference.
Why doesn’t the Wood Pack snap & crackle
like a traditional wood fire?
The irregularities in wood logs cause the
snapping and crackling. The wood pellets in a
Wood Pack do not contain the irregularities that
are found in wood logs.
How do I extinguish in an emergency?
Stand back at least 5 ft. and spray with a garden
hose to avoid hot steam and debris. Spray coals
continuously for 5 minutes or until coals have
cooled. Empty ash pan and thoroughly dry the
Fire Pit to prevent rust from forming. Refer to
the instruction manual for more information.
How do I clean out the ash from the bottom
of the Fire Pit?
Remove the center cone and carefully sweep ash
through bottom holes. Once all the ash has been
swept through the holes, remove the ash pan
and dispose of ash properly.
How often do I need to empty the ash
catcher pan?
The pan should be emptied after every use.
How do I clean the Fire Pit?
If soot or ash has accumulated on the outside of
the Fire Pit, wipe down with a damp cloth.
How long do I have to wait before I put the
cover on?
If using the TIKI® Brand Wood Pack, this should
take approximately 6-8 hours and is designed to
completely consume leaving minimal ash. If you
are using wood logs, times will vary depending
on the amount of wood used and consumed.
Be sure to clean out all ash to ensure there are
no embers left over before putting the cover on.
Where do I buy more
TIKI® Brand
Wood Packs?
tikibrand.com.
Where do I buy TIKI® Brand Fire Pit accessories?
tikibrand.com.
For more information on our warranty and other
things you should know, refer to the instructions
and user manual also included in this box or visit
tikibrand.com.