Time2 Water Sensor v1.1 User manual

Water Sensor User Guide
The water sensor detects water and transmits a signal to the Noah
hub triggering an alarm.
Features
Tamper Alarm
If an intruder attempts to remove or damage the sensor, a tamper
alarm is triggered and the user is notified immediately.
1. Transmitter
2. Leak detection cable
3. Water sensor
4. Pairing button
5. Battery compartment

Pairing the water sensor to the Noah Hub
1. Open the Clan at Home app on your smartphone or tablet
2. Click Noah Alarm System
3. Press the icon to enter the accessories menu
4. Press the (+Add) icon.
The Noah hub LED will turn purple when
it is ready for pairing.
5. Remove the back cover from the back of the
water sensor. Press the pairing button.
6. The Noah hub LED will flash green once and make a beep sound
when it has paired successfully.
The water sensor will appear under the sensor list on the App. Please
note: the water sensor is set in Always On Zone by default.

Installing the water sensor
1. Open the back cover of the sensor, check the battery is fitted
properly
2. Ensure the area that the sensor will be located is
clean and free from dust and moisture.
The sensor should be around 1-2mm away from
the surface you are monitoring, the sensor should
not be touching the surface.
3. Use the provided screw to fix the sensor securely
4. Once the sensor has been fitted, use the adhesive
strip to carefully mount the sensor.