TIME2TECHNOLOGY RF User manual

RF Repeater User Guide
Connect the RF repeater to the Noah hub to extend the RF range for
paired sensors. The built-in LED lights up to let you know Noah’s
status.
Installation
1. Fix the 3-pin adapter on to the RF repeater by aligning the pins
2. Rotate the adapter clockwise to fix it securely to the RF repeater
3. Plug in to a wall socket and ensure the power is on
1. LED indicator 2. Pairing button
Red LED: Pairing mode 3. Plug handle
Green LED: Noah disarmed Press the handle down and
Blue LED: Noah armed rotate to add or remove plug
Green LED flashing: Transmitting signal
Blue LED flashing: Noah in home mode

The RF repeater is powered using the mains power socket. The back-
up battery is for emergency use only, when the power supply is cut
unexpectedly.
Pairing the RF repeater to the Noah Hub
You will need the following to pair the siren to the Noah hub.
-RF repeater
-Noah hub
-Remote control (provided with the Noah hub)
-Clan at Home app on your smartphone
1. Plug the RF repeater in to a mains power socket. The LED will light
up.
2. Open the Clan at Home app on your smartphone or tablet
3. Click Noah Alarm System
4. Press the icon to enter the accessories menu
5. Press the (+Add) icon.
The Noah hub LED will turn
purple when it is ready for
pairing.

6. Press the pairing button on the side of the RF
repeater.
The repeater will enter pairing mode –the LED will
turn red and make a beeping sound
7. Use the remote control to arm Noah. The LED on the RF repeater
will flash once when it has paired successfully.
8. Then press the pairing button on the side of the RF
repeater again.
9. Lastly, test the RF repeater by using the remote control to arm Noah
again. The LED will turn blue.
Please note: The RF repeater does not appear in the Accessories
menu.
Unpairing the RF repeater from the Noah Hub
Hold the pairing button down for 5 seconds until the RF repeater
makes a beeping sound