TJERNLUND 9900000 User manual

TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE [phone] • [phone] • FAX [phone]
Visit our web site • www.tjernlund.com
Large Burning Box (9900000)
WARNINGS:
• Do not handle these parts without hand protection! All parts of this product
are made of Stainless Steel which can have sharp edges!!! Gloves have
been provided for the user to wear during the assembly, handling and use
of this product.
• Never leave this product unattended! This product must be supervised
when in use and stored out of reach of children and unprotected adults
when not in use.
• Never use this product within 15 feet of combustible materials. This device
gets extremely hot when in use and can start adjacent combustible mate-
rials on fire.
• Always insure the burning materials in this device are 100% extinguished
before no longer supervising it.
• Never touch this product when in use. It does burn extremely hot and will
very quickly burn anything that touches it including human flesh.
• Never have children within 20 feet of this product. Cuts or burns can result
if the product is touched or handled without hand protection.
CAUTION: The parts of this product can have sharp edges and can cause
cuts if not handled properly. Wear a set of gloves ANYTIME this product is
handled. Put provided gloves on to assemble this product. Make sure all
parts are accounted for. Place parts in an orderly manor on a surface where
they can be easily identified.
READ INSTRUCTIONS CAREFULLY
PRIOR TO ASSEMBLY & OPERATION
Caution: Do Not use accelerants in the burn barrel. Accelerants
produce high concentrations of heat that can cause damage to the
Burn Barrel! Warped Burn Barrel parts are not covered by the war-
ranty of this product.

ASSEMBLY
Fasten the (4) side panels together using a drill with 1/4” nut runner
bit and a 11/32” nut driver or wrench to hold nut on inside, install (5)
of the 3/8” X 8-32 stainless bolts and nuts down each corner.
Locate the (4) feet and form the tabs on the feet as shown. The tabs should be formed up
and should be about 90 degrees from the base foot.
Locate the bottom of the Burning Box by identifying the mounting holes for the feet. Position the Burning Box with the bottom
side of the Box facing up as shown. Position the feet and mount them in place.
Locate the (4) Burning Material Support Brackets and form the tabs using a pliers as shown. Install the first (2) support brackets
into the Box as shown using the holes furthest away from the feet. The (2) brackets are to be mounted side by side from each
other and run parallel across the box.

Install the last (2) support brackets as shown. Use the set of holes in the box that are
closest to the feet.
Locate the (3) handles. The rolled over material on each handle is to be
located on the inside of the handle. Manually form the (3) handles into
shape using a pliers.
Mount (2) of the handles to the sides of the Burning Box. The handles are to be positioned and mounted on opposite side of the
Burning Box. Mount the last handle to the outside surface of the Burning Box Cover.
©2016 TJERNLUND PRODUCTS, INC. ALL RIGHTS RESERVED P/N: 8504226 REV A 1016