TLC TL3500H User manual

TL3500H 36W CFL FLOOD LIGHT INSTRUCTION
Read allinstructions beforeproceedingwithinstallation.
We stronglyrecommendthat this floodlight shouldbe installed
by a qualifiedelectrician.
SPECIFICATONS:
Power Source: 220
- 240V AC 50Hz
Loading: 36W
WIRING INSTRUCTIONS
1. This HalogenFloodlight has three wires:
Brown-Live
Blue-Neutral
GreenNellow-Earth
Connectthese wires to 220 - 240 voltAC power source.
2. Refer to the following diagram for wiring connectionusingthe terminalblock
Connect to lampholder
*
TO AC POWER CABI~
3. Use the greeniyellowwire to earth the fixture.
4. Double check the connections afler wring as errors may damage the lamp or cause a fire hazard.
MOUNTING POSITION:
-The rear and two sides of the lamp shouldbea distance of50mm fromthe mountingsurface
- The distance betweenthe frontofthe glass andthe illuminated surfacemustbe 2 0.5m.
- Theplace where the lamp is mountedshouldbekept dry andclean.
LAMP TUBE FITTING:
Unscrew the bolt and open the glass holder. Turn the pin slots of the tube holders on both ends vertically (see
figure.2); While the tube pins are in the tube holders on both ends, turn the tube at 90° (see figure.
3). Close
the glass holder with the bolt. The tube cannot befittedwithbarehands.

CAUTION:
1. This lamp must be installed by a qualified electrician. Switch off the power before the installation to
avoid electric shock.
2. If the shieldingglass is cracked or the lamp is not working, ensure they are disposed of by a qualified
electrician.
3. This lamp can not be used under a sealed space or inflammable, explosive surrounding.
4. Use after verificationof the input voltageof this lamp is in compliance with the local voltage.
5. An interval of 1 minute is required before restartingthe lamp.
6. Switch off the power beforecleaning the lamp.
7. This shall be deemed as normal while the initial lumen is inadequate when switching on the power
Afler
3 - 5 minutes the lumen will reach the normal level.
CARE AND MAINTENANCE:
Your portable worklightrequires very little care or maintenance. Simply clean the lens and stand regularly
with a non
- abrasivecleaner.Be sure the lamp is turned off and ample time is given to cool before
cleaning.