TLW VEW K30-2038CCTZ User manual
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Kit Contents
▪CCT dimming Zigbee wall switch
Important Safety Information
DISCLAIMER: PLEASE NOTE INSTALLATION SHOULD BE CARRIED OUT BY A
QUALIFIED ELECTRICIAN!
•This Zigbee CCT wall switch is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
•This Zigbee wall switch supports 4 groups for binding max. 30 lighting devices and enables to control
tuneable white Zigbee lighting devices.
•DO NOT install with power applied to the device.
•DO NOT expose the device to moisture.
Function Introduction
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Installation
Zigbee Network Pairing through Coordinator or Hub (Added to a Zigbee Network)
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Note: 1) After pairing successfully, the remote information will appear on the controller or hub interface.
2) No remote information will appear on the hub interface if pairing to Philips Hue Bridge.
TouchLink to a Zigbee Lighting Device
Removed from a Zigbee Network through Coordinator or Hub Interface
Factory Reset Manually
1
From your ZigBee controller or hub interface, choose to delete or reset the remote as instructed,
indicator flashes 3 times quickly to indicate successful removing.
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Remove a Touchlink Paired Zigbee Lighting Device
Factory Reset a Lighting Device (Touch Reset)
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Find and Bind a Zigbee Lighting Device
Find and Unbind a Zigbee Lighting Device
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Clear All Find and Bind Mode Paired Lighting Devices of a Group
Setup a Network & Add Devices to the Network (No Coordinator or Hub Required)
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
How to Check Whether the Remote Belongs to a Network or not
Wiring Diagram
Installation
1
Short press any other buttons except group buttons, indicator blinking means the wall switch has already
been added to a network, no blinking of indicator means the wall switch does not belong to any
network.
Product Name: Swipe CCT CCT LED Dimming Zigbee Wall Switch
Product Code: K30-2038CCTZ
Other Information
Specifications:
•Zigbee CCT wall switch based on ZigBee 3.0
•Full touch glass interface, smooth CCT and light intensity control
•Enables to pair ZigBee lighting devices via touchlink commissioning without coordinator
•Supports find and bind mode to pair with Zigbee lighting devices in the same network
•Supports 4 groups for binding max. 30 lighting devices
•2.4 GHz global operation
•Transmission range up to 30m
•Compatible with universal Zigbee Gateway products
•Compatible with universal CCT ZigBee lighting devices
Zigbee Clusters Supported by This Wall Switch Are As Follows:
Input clusters:
•Basic •Power Configuration •Identify •Diagnostics
Output clusters:
•Identify •Scenes •Group •On/off •Level control •Colour control •OTA
OTA
The wall switch supports firmware updating through OTA, and will acquire new firmware from Zigbee
controller or hub every 10 minutes automatically.
Product Data
Table of contents
