Atlona AT-HDVS-150-TX-WP Technical manual

1
Atlona Technical Support: +1 877.536.3976 option 1
Update Instructions
AT-HDVS-150-TX-WP
The following procedure is used for updating the rmware for the AT-HDVS-150-TX-WP. This process applies to both
the AT-HDVS-150-TX-WP-US and AT-HDVS-150-TX-WP-UK models.
Requirements
• AT-HDVS-150-TX-WP-US or AT-HDVS-150-TX-WP-UK
• Firmware le: AT-HDVS-150-TX_[version].bin
• USB Type A to Mini-USB Type B cable
• Computer with USB port
1. Download the latest rmware from the Atlona web site.
2. Remove the AT-HDVS-150-TX-WP from the wall, or other surface, by removing the four screws from the front of
the wall plate.
3. Disconnect the power to the AT-HDVS-150-TX-WP by disconnecting the Ethernet cable from the HDBaseT OUT
port on the AT-HDVS-150-TX-WP.
4. Remove the faceplate from the front of the AT-HDVS-150-TX-WP, by unscrewing the two locking connectors for
the VGA IN port and the locking connector for the HDMI IN port, using a small hex driver or pliers.
LINK
HDMI IN
VGA IN AUDIO IN
DISPLAY
ON/OFF
INPUT
SELECT

2
Atlona Technical Support: +1 877.536.3976 option 1
Update Instructions
5. Press and hold the DISPLAY ON/OFF button, while connecting the USB cable from the computer to the mini-
USB port on the AT-HDVS-150-TX-WP.
6. After a few seconds, a folder with the name USB UPDATER, will be displayed. Release the DISPLAY ON/OFF
button.
If the folder is not displayed, open Windows Explorer and locate the drive named USB UPDATER.
7. Delete all les from the USB drive, if any are present.
8. Drag-and-drop the AT-HDVS-150-TX_[version].bin rmware le to the drive.
9. After the le has been copied, disconnect the USB cable from both the computer and the AT-HDVS-150-TX-WP.
10. Reconnect the Ethernet cable to the HDBaseT OUT port on the AT-HDVS-150-TX-WP.
11. The rmware update process is complete.
12. Attach the faceplate then reinstall the AT-HDVS-150-TX-WP.
mini-USB port
DISPLAY ON/OFF button