Tollco WaterFuse PlugIn VFB700-DN15 Manual

1(8)
WaterFuse® - PlugIn
User Manual
&
Installaon Instrucons
(Applicable to RSK no.: 5216566, 5216567, 5216568 and 5216569)

2(8)
Safety
Read this manual carefully and follow the instructions for placement and
usage.
The product may only be connected by a qualified installer. The warranty does
not cover repairs of faults caused by faulty installation or incorrect use of the
appliance.
Recycling
Used products must be left at a collection point for the recycling of electrical
and electronic components. By ensuring that the product is handled correctly,
you help to prevent any negative environmental and health effects that may
occur if the product is disposed of as normal waste. For further information
on recycling, please contact local authorities, your household waste disposal
service, or the shop where you purchased the item.
Refers to WaterFuse PlugIn with article number,
VFB700-DN15, VFB700-DN15X2, VFB700-DN20 and VFB700-DN20X2.
RSK no.: 5216566, 5216567, 5216568 and 5216569
Edition 28/02/2020
!

3(8)
Table of Contents
1. User Manual 4
1.1 General 4
1.2 Handling 4
1.3 Alarm 4
2. Installation Instructions 5
2.1 Installation 5
3. Technical Specification 6
4. Warranty and Limitation of Liability 7

4(8)
User Manual
1.1 General:
The product must be installed by a person who has the professional knowledge required to
perform the installation correctly. Unless the installation is performed by a professional, the
insurance companies may claim that the insurance does not cover any damage that has occurred
and that the offers made by the insurance companies to the property owner are invalid.
WaterFuse PlugIn is used to prevent water damage around equipment or in a limited area, such
as a sink unit/dishwasher. WaterFuse PlugIn can be installed with one or two motorised ball
valves and with one or two water sensors. If the ball valve remains open for more than three
days, the ball valve will be exercised automatically; however, the water will not be completely
turned off.
1.2 Handling
• Press ON on the WaterFuse PlugIn to turn the water on, press OFF to turn the water off.
• The water sensor continuously monitors the area for water and at an indication of water
the system sounds the alarm and the water is turned off. See section 1.3 Alarm.
• A 230V electrical socket can be used to connect the monitored equipment, such as
a dishwasher.
Note! The OFF button on the WaterFuse PlugIn does not turn off the 230V, only the water.
1.3 Alarm:
• The water sensor indicates water
If the water sensor has indicated water, the unit gives a pulsating warning signal, the water is
automatically turned off and the LED indicator flashes red. Press RESET to silence the system
and fix the leak. When you have fixed the lead, press ON and the water will be turned on again.
If one or more of the water sensors are still wet, the system will sound the alarm again and turn
off the water.
The 230V socket will still be functional. If you want the system to shut down the electricity too in
case of an alarm, read section 2.2 Settings.

5(8)
2 Installaon Instrucons
2.1 Installation:
Electronic Unit:
Fitted to a 230V socket. The socket can still be used, for example for a dishwasher. In the basic
setting, the electrical socket continues to function with 230v also during an alarm. To change
this setting, see section 2.2 Settings.
Motorised Ball Valve
The cable from the motorised ball valve is connected to the electronic unit. One or two ball
valves can be installed. See image 1. The valve can be mounted horizontally, vertically, or upside
down and independent of flow direction. The unit has an internal R-thread. Connect them to
pipes, for example with compression fittings according to the installation instructions from the
pipe and fitting manufacturer. After completing the installation, conduct leak testing.
Water Sensor:
The accompanying sensors are placed in the area intended to be protected and connected to
the electronic unit. Connect using the plug that came with the unit. See image 2.
Connections for the valve are on the
right side of the unit.
(2 valves can be connected)
Image 1
The water sensor is connected on the
left side of the unit.
(2 sensors can be connected)
Image 2

6(8)
2.2 Settings:
The electronic unit comes with the basic setting allowing the 230v socket to be used despite a
water leak alarm. This means that the product can be safely installed with a fridge or freezer
without risk. Dishwashers and washing machines are built to function without a water supply,
even when they are in operation.
When the electronic unit is plugged into a 230v socket, it will start up and flash GREEN if the
electricity will remain on after a water alarm. It will flash RED if the electricity will be turned off
in the event of a water leak.
To change the setting:
- Press the buttons ON/OFF and TEST/RESET simultaneously for three seconds.
- There will be a beep and the new setting is indicated by a flashing GREEN or RED light.
(Green = 230v ON after a water alarm. Red = 230v OFF after a water alarm)
- All done!
3 Technical Specicaons
EL VHP
230 V / 3680W DN15 alt. DN20
1–2 water sensors 1 -2 motorised ball valve with
manual override

7(8)
4 Warranty and Limitaon of Liability
In addition to the terms of the Consumer Purchase Act, a 1-year functional warranty is provided for the
product.
The warranty stipulates that during normal use and maintenance, the product must be free from defects
in design and function. The warranty period is calculated from the date of purchase, which must be proven
by a receipt from the place of purchase. The warranty presupposes that the product has been installed
appropriately and in accordance with the written instructions. The plumbing installation must be completed
by a plumber.
If you have questions or problems with your product, you should first contact the dealer who sold or installed
your equipment. Before you report a fault /complaint about your broken product, please read the operating
instructions and, if possible, check that all settings are correct. The warranty stipulates that defective parts
or components will be replaced with defect-free ditto. The customer is responsible for all overhead, unless
the Consumer Sales Act is applicable. This means that shipping costs, inspection, and assembly costs are
not included in the warranty commitment. If possible, use the original packaging if the product needs to
be transported. The transport companies do not compensate for damage if the product has been poorly
packaged.
The warranty does not apply to defects that occur during or after making your own changes to the product's
function or appearance, such as rebuilding, upgrading, or other configurations of the product made without
written approval.
The warranty does not cover faults that have arisen through an accident or malicious damage. . The warranty
does not cover deterioration that has occurred after the purchase, if the seller can prove it probable that the
deterioration is due to neglected or incorrect maintenance or that the appliance has been used for something
other than its intended purpose, that inappropriate measures, unauthorised or incorrect interventions have
been made or that installation instructions were not followed.
Batteries are considered consumables and are not covered by the warranty.
The reseller is not responsible for loss or damage of any kind caused by this product. The liability is, in any
case, strictly limited to the replacement of the product.

8(8)
Tel: [phone]
[e-mail]
www.tollco.se
Tollco AB
Rubanksgatan 4
741 71 Knivsta
Accepterad
monterings-
anvisning
2016:1