Toolland VL104 User manual

VL104
EN
GAS WEED BURNER
NL
ONKRUIDBRANDER OP GAS
FR
DÉSHERBEUR THERMIQUE À GAZ
ES
QUEMADOR DE MALAS HIERBAS - GAS
DE
UNKRAUTBRENNER - GAS
PL
PALNIK GAZOWY DO WYPALANIA CHWASTÓW
PT
QUEIMADOR DE ERVA A GÁS
USER MANUAL 3
HANDLEIDING 7
MODE D'EMPLOI 11
MANUAL DEL USUARIO 15
BEDIENUNGSANLEITUNG 19
INSTRUKCJA OBSŁUGI 23
MANUAL DO UTILIZADOR 27

VL104
V. 01 –26/01/2017 2 ©Velleman nv

VL104
V. 01 –26/01/2017 3 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or to
a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
Outdoor use only.
Keep this device away from children and unauthorized users.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children shall be supervised to ensure that they do not play with the appliance.
There are no user-serviceable parts inside the device. Refer to an authorized dealer for service and/or
spare parts.
Keep this device away from rain, moisture, splashing and dripping liquids.
Do not use near inflammable products or in explosive atmospheres. Heat can cause fire to
inflammable products even when they are not in sight. Only use in properly ventilated areas.
Device heats up during use. Never touch the nozzle or heat shield while using the device. Let the
device cool down for 30 minutes. Some parts of the device get really hot, even after a short use.
Device
Only assemble and use the device as described in this manual.
Never modify or repair the device yourself but have it repaired by qualified personnel.
Only use accessories approved by the manufacturer.
Gas Canister
Carefully read the user manual before connecting a gas canister.
Check the hose before every use. Do not use the hose if it is visibly damaged or worn.
Make sure all parts are ready to be used before connecting the gas canister.
Connect the gas hose to the burner first and then to the gas canister.
Always connect the gas canister outside or in a properly ventilated room, away from open flames, sparks
and electronic devices. Keep bystanders at a safe distance.
Never smoke when handling gas-related devices or connecting the gas canister.
Make sure all taps, valves and connections on the burner and canister are undamaged, properly fitted and
closed.
Check all connections for gas leaks and make sure they are gastight before every use.
Protect gas canisters from extreme temperatures and damages. Replace damaged parts in time.
Replace the hose at most every 5 years after their production date, sooner after intensive use or exposure
to harsh circumstances (heat, cold, rubbing…). It is advised to replace the hose every 3 years.

VL104
V. 01 –26/01/2017 4 ©Velleman nv
During Use
Stay alert, watch what you are doing and use common sense when operating the device. Do not use the
device when you are tired or under influence of drugs, alcohol or medication.
Do not overreach. Keep proper position and balance at all times.
Dress in a suitable manner. Do not wear loose clothing or jewellery. Keep hair, clothing and gloves away
from moving parts.
Never aim the device directly at humans or animals.
Do not use the device as a heat source in your house or for melting ice and snow or for any other use than
intended.
Always point the nozzle at the ground and away from persons, animals and objects.
Never use the burner in a cellar or closed rooms, near heat sources or open flames, and near inflammable
products and materials. Keep bystanders at a safe distance.
Do not inhale the fumes released by the burner.
Never wring or twist the hose and protect it from sharp objects.
Switch off the burner when it is not in use and close the gas tap on the gas canister. Never leave the burner
unattended.
Using a new gas canister can affect the flame due to thermal differences. This is normal and the flame will
re-adjust after a few minutes of use.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
Unplug the device immediately if the cable has been damaged.
Never block the air intake of the device.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
This device is not intended for professional use.
This device serves exclusively to eliminate sprawl between paving stones, on paved areas, from masonry,
in flower beds and lawns during the growth period.
Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
hose connection
4
lighter nozzle
2
gas flow regulator valve
5
regulator
3
handle
6
hose

VL104
V. 01 –26/01/2017 5 ©Velleman nv
5. Operation
5.1 General Operation
1. Connect the pressure regulator [5] to the gas canister.
2. Connect the gas hose [6] to the pressure regulator [5] and the handle [3]. Remember that the screw
threads are left-handed.
3. Make sure all parts are properly connected and perform a gas leak test (see below). You can switch on the
weed burner only if it has passed the gas leak test.
4. Slowly open the gas tap. Then, slightly open the gas flow regulator valve [2] on the handle [3]. Be careful
not to open it too much as the gas pressure could blow out the flame. Let the air escape from the hose [6]
and burner, and wait until you hear the gas flow.
5. Slowly open the gas flow regulator valve [2] on the handle [3] to increase the gas pressure. Bring a flame
in front of the lighter nozzle [4]. Let the flame burn for a few seconds. Make sure not to let the flame grow
too much as this will decrease efficiency.
6. Pinch the handle [3] to produce a pointed blue flame. The flame size depends on how far the gas flow
regulator valve [2] is opened. Remember to point the flame at the ground and away from persons, animals
and objects.
7. Keep the nozzle [4] at a distance of approximately 15 cm of the weed. Gently waft the nozzle
approximately 5 seconds over the weed. Do not burn the plant completely, only the heat is needed.
Stronger weeds or woody stems (wild grass, roots, etc.) may require a repeat application. If necessary,
repeat this procedure after a few days. Do not use this device on flower beds or lawns.
8. Release the handle [3] to pause; the blue flame will disappear and the yellow flame will reappear. If
necessary, reduce the gas pressure by slightly closing the gas flow regulator valve [2]. Make sure not to
leave the pilot light burning when interrupting your work for more than a few seconds.
9. To switch off the burner, first close the gas tap completely and let the gas inside the burner consume. Only
when the pilot light has extinguished can you close the gas flow regulator valve [2] completely.
WARNING
Never touch the nozzle immediately after use. Risk of burn injuries!
Leave the weed burner to cool completely before disconnecting and storing.
10. Disconnect the hose [6] from the gas canister. Always move a gas canister in its vertical position. Store
your weed burner and gas canister properly. Never refill or modify a gas canister.
5.2 Checking for Gas Leaks
Check for gas leaks before using the weed burner. Always perform the test in the open air.
1. Carefully close the gas tap and make sure to use a full gas canister.
2. Prepare a test solution made of one part liquid soap and one part water.
3. Use a brush, cloth or plant mister and apply the soapy solution on every (hose) connection and part where
a leak is suspected.
Test all connections for gas leaks using a soapy solution.