Topdon JUMPSURGE 3000 User manual

Jump Starter USER MANUAL
JUMPSURGE
3000

WELCOME
ABOUT
SAFETY CAUTIONS
Thank you for purchasing the JUMPSURGE3000. If any
issues arise during the use of this product, please contact
[email protected] for ofcial technical support.
The JUMPSURGE3000 is a portable jump starter that
delivers 3,000 peak amps for jump starting a 12V lead-acid
battery in seconds. It supports quick and safe starts for
12V cars, boats, motorcycles, ATVs, lawnmowers, caravans,
tractors, trucks, etc., with up to 9.0-liter gasoline or 7.0-liter
diesel engines. It is able to jump start the batteries 45 times
on a single charge.
It also functions as a power bank to quickly charge
electronic devices like phones and tablets, or supply power
to DC devices.
Please read this manual carefully before using the tool and
keep it for future reference.
1. ONLY use the battery clamps that come with this product.
the battery manufacturer.
2. DO NOT use this product if the cable or the jump starter
has any damage.
3. This product can only be used for starting vehicles with
12-volt lead-acid batteries.
4. Only jump-start vehicles when the battery level of the
jump starter is above 50%.
5. If the engine does not start successfully on the rst try,
disconnect the clamps from the vehicle battery and wait
at least 20 seconds before reconnecting. DO NOT attempt
more than 3 consecutive jump-starts within 2 minutes.
6. DO NOT put the product under direct sunlight or in high-
temperature areas.
7. DO NOT disassemble the product by yourself.
EN |5

8. DO NOT place the product in high-temperature
environments for a long time. The JUMPSURGE3000's
working temperature is of -10℃~40℃(14 ℉~104 ℉).
9. Check the battery level of this product every two months
and charge it regularly.
10. The JUMPSURGE3000 contains a Lithium-Ion Battery.
Please dispose of it under local regulations at the end of its
life.
WHAT'S INCLUDED
JUMPSURGE 3000
Battery Clamps
USB Cable
Adapter
EVA Carrying Bag
User Manual

PRODUCT OVERVIEW
EN |7
LED
Light
Hook Stand
Socket For
Battery Clamps
DC Out (Max
16.8V/10A)
USB Out
(5V/2A) Type-C In (5V/3A, 9V/3A, 12V/3A, 15V/3A)
Type-C Out (5V/3A, 9V/3A, 12V/3A, 15V/3A, 20V/2.25A)
Battery Level
Indicator
Power Button
Status Indicator
BOOST Button
USB Out (5V/3A,
9V/2A, 12V/1.5A)
Handle

A Guide To The Status Indicator:
If The Light is Solid Green:
The voltage of the vehicle battery is normal. You can jump-
start the vehicle with the JUMPSURGE 3000.
If The Light Doesn't Turn On:
The voltage of the vehicle battery is too low to be detected.
Press and hold the BOOST Button for around 3
seconds until it lights up. Then, the jump starter will enter
a forced output mode. Start your vehicle within the next 30
seconds.
Note: The forced output mode disables all safety protections
temporarily. Therefore, only use this mode when the vehicle
battery is extremely low.
Positive Clamp (Red) Negative Clamp (Black)

RECHARGE THE JUMP
STARTER
A Guide To The LED Light:
The JUMPSURGE3000 comes partially charged and needs
to be fully charged before use. Please charge your jump
starter through the Type-C In port once you receive it.
Note:
Only jump-start vehicles when the battery level of the jump
starter is above 50%.
Press the Power Button once to turn on the jump-
starter.
Press and Hold the Power Button for 3 Seconds to
turn on the LED Light. Then Press the Power Button once to
toggle between Flashlight, Strobe, SOS, and POWER OFF.
EN |9

Step 2:
Connect the other end of the battery clamps to the vehicle
battery. Red clamp to positive polarity(+), black clamp to
negative polarity(-).
Step 3:
Press the Power Button once to power on the jump
starter. The Battery Level Indicator
will light up, which means the tool is ready to jump-start a
vehicle. The Status Indicator will turn green which
HOW TO JUMP START
VEHICLES(12V ONLY)
Important:
Before attempting to jump-start a vehicle, make sure
you have turned off all of the power loads of the vehicle,
including headlights, radio, air conditioning, etc.
Step 1:
Plug the blue end of the battery clamps into the socket on
the jump starter.
(Red) (Black)

Notes:
* If the Status Indicator doesn't turn on, press and
hold the BOOST Button to enable the forced output
mode.
* The jump starter has a built-in buzzer that will ring when
a reverse polarity, over-temperature, over-circuit, and other
improper connections are detected. Disconnect the jump
starter if the buzzer rings and connect again after the issue
is resolved.
Step 4:
Try starting the vehicle. If it fails, disconnect the clamps
from the vehicle's battery and wait for 20 seconds, then
reconnect and try again. Do not attempt more than 3
consecutive jump-starts within 2 minutes.
EN |11
means the vehicle battery voltage is normal and ready for
jump-starting.

This jump starter is able to be used as a power bank.
Press the Power Button once to turn on the
JUMPSURGE3000. Then you can quickly charge your phone
or tablet through the USB Out port, and quickly charge
your laptop through the Type-C Out port. You can also use
it to supply DC power (Max 16.8V/10A) to other automotive
devices, such as tire inator or car fridge, through the DC
Out port.
Step 5:
After successfully cranking the vehicle, the jump starter
will automatically power off in 10 seconds without any
operation. Remove the clamps from batteries and separate
the clamps and jump starter.
(Red) (Black)
Other Functions

SPECIFICATIONS
FAQ
Model
Battery Capacity
USB1 Output
USB2 Output
DC Output
Type-C Output
Type-C Input
Peak Current
Operating Temperature
Storage Temperature
JUMPSURGE3000
24,000mAh, 3.7V/88.8Wh
5V 3A, 9V 2A, 12V 1.5A
5V 2A
Max 16.8V 10A
5V 3A, 9V 3A, 12V 3A,
15V 3A, 20V 2.25A
5V 3A, 9V 3A, 12V 3A,
15V 3A
3000A
-10℃~40℃(14 ℉~104 ℉)
-20℃~75℃(-4 ℉~167 ℉)
Q1: How many times can the JUMPSURGE3000 jump start
a car with a full charge?
Up to 45 times. It depends on the vehicle engine's power
and the vehicle battery's power.
Q2: How long does it take to fully charge the JUMPSURGE3000?
It varies depending on the adapter. The adapter that comes
with the JUMPSURGE3000 is a 5V/3A, and its charging time
is of approximately 6 hours.
Q3: How to turn off the JUMPSURGE3000?
The device will automatically power off after 10 seconds
without operation.
EN |13