Topeak Shock 'n Roll User manual

NOTE
• Before using Shock 'n Roll to inflate your suspension fork or rear shock,
check and do not exceed factory recommended pressures.
• Make sure to choose the correct Inflation Mode (Tire Mode or Shock Mode)
before engaging pump valve to the valve stem. DO NOT switch Inflation
Mode when the pump valve is still engaged on valve stem to avoid the
leakage of air.
1
2
5
6
7
8
4
6
1
2
3
4
Air Release Button (works with Schrader Valve only)
Dial Gauge (0-300 psi/ 0-20.7 bar)
Rotating Hose
Ination Mode Selection
SmartHead™ThreadLock ts both Presta and Schrader valves
Hose Dock
Vent Hole *
High polish Aluminum Barrel
MTB TIRE mode SHOCK/FORK mode
5
6
7
8
A small amount of air pressure will escape from the vent hole
when inflating suspension fork or rear shock. It's normal and
won't affect inflation.
* NOTE of Vent Hole
User's Guide
Shock 'n Roll
GB
Presta Mode
Schrader Mode
3
DO NOT block the vent
hole while inflating in
Shock Mode.
Doing so will adversely
affect inflation.

User'sGuide
Shock 'n Roll
2-yearWarranty: Allmechanicalcomponents against
manufacturer defects only.
WarrantyClaimRequirements
To obtain warranty service, you must have your
original sales receipt. Items returned without a sales
receipt will assume that the warranty begins on the
dateofmanufacture.Allwarranties will be voidifthe
productisdamaged due to user crash,abuse,system
alteration, modification, or used in any way not
intended as described in this manual.
*Thespecificationsanddesignaresubjecttochange
without notice.
Pleasecontact yourTopeak dealerwith
anyquestions.
ForUSA customerservice
call: 1-800-250-3068
www.topeak.com
WARRANTY
M-TSNR-1-GB 03/12
Copyright ©Topeak, Inc. 2012
DISENGAGE
TIRE MODE
MTBTIRE mode Presta valve as example
For Presta valve
For Schrader valve
Presta Mode
Schrader Mode
ENGAGE
SHOCK MODE (Schrader mode)
SHOCK/FORKmodeMTBTIRE mode
Twist the barrelto Shock Mode.