TOPigeon iPigeon User manual
iPigeon
Using the Loft Recorder
Power up the iPigeon and select the Communication icon
In the next screen at Connector change Disable to Channel 1
If you have 2 clocks select Channel 2 for the second clock
Then select the Save button followed by the Device Reset button
The iPigeon will now close down and power up again
and note the RF icon at the top will have changed from brown to grey
Now power down the iPigeon and remove the power cable
Without powering up anything
Firstly connect the Loft Recorder to the first landing pad
Using either end of the Mini-DIN cable connect to either of the Loft Recorder Ports
Then connect other end of the Mini-DIN cable to to the iPigeon
Now connect power lead to the Loft Recorder (not the IPigeon)
Everything is ready to record arrivals in the Loft Recorder when the clock is removed to go to the
club (remember to take the Mini-DIN cable to the club if marking is on another make Ring Marker)
Upon your return from the club, just connect the iPigeon and any returned birds will be
uploaded from the Loft Recorder into the iPigeon
iPigeon Setting up the Loft Recorder
If you do not intend using the Loft Recorder on any subsequent races
remember to set Channel numbers back to Disable
After powering up notice the RF icon is now back to brown
Loft Recorder Led lights: Power on: Loft Pad connected: ETS ring over Loft Pad:
Other manuals for iPigeon
2
Table of contents
Other TOPigeon Data Logger manuals
