Topmaz Racing 84470 User manual
1
Pack
NO.: 84470
1:12
SCALE
FULL
FUNCTION
6
ages
RACING BIKE
PRO . S Y S TE M
ADAPTOR
3.7V
Rechargeable
Battery
Rech arge able B attery Must Be
Recycled Or Disposed Of Pr operly.
Contents
5
RC Transmitter x 1
-RC Vehicle (Vehicle) x 1
-RC Transmitter (Transmitter) x 1
3.7V Lithium
-
USB Cable Adaptor x1
3.7V
150mAh
For Vehicle
-Instruction Manual x 1 RC Vehicle x 1 USB Cable Adaptor
(Included)
1.
The 3.7V rechargeable battery ack must be charged before use by utilizing the USB
Cable Ada tor which included.
2.
Do not overcharge the battery ack. Do not charge for more than 4 hours.
3.
Do not charge the battery ack if it shows leakage, corrosion, or has loose or ex osed
wires or other damage.
4.
Do not cover the battery ack with any sort of materials while charging.
5.
Do not touch the battery ack when it is hot. Wait until the battery ack cools before
installing it in the Vehicle and before recharging.
6.
Do not dis ose of the battery in fire.
7.
Do not dismantle the battery or charger, and do not cut the battery or charger cables.
8.
The battery ack will be warm after charging, and hot after use in a vehicle.
9.
The su ly terminals are not to be short-circuited.
10.
Rechargeable batteries are only to be charged by adults.
11.
Battery re lacement must be only made by adults.
12.
The USB Cable Ada tor is not a toy.
13.
Charge only ty e (150mAh Max.) rechargeable battery acks. Other ty es of
batteries may burst causing injury to ersons and damage. This ower unit is
intended to be correctly orientated in a vertical or floor mount osition. This
USB Cable Ada tor is intended to be used for charging 3.7V rechargeable
battery ack with ca acity 150mAh Max. It cannot be used for charging
non-rechargeable batteries. Regular examination of USB Cable Ada tor for
any damage to their cord, lug, enclosure and other arts, and that, in the
event of such damage, it must not be used with the charger or battery ack
charge until such damage has been re aired. Note that the AAA battery is
non-rechargeable and is not to be recharged. Only batteries of the same or
equivalent ty e as recommended are to be used. It will need re lacement
when transmission is oor.
14.
Exhausted batteries are to be removed from the roduct.
15.
Non-rechargeable batteries are not to be recharged.
16.
Diuerent ty es of batteries or new and used batteries are not to be mixed.
17.
Rechargeable batteries are to be removed from the toy before being charged.
18.
Batteries are to be inserted with the correct olarity.
19.
The ackaging has to be ke t since it contains im ortant information.
Battery Installation
For Transmitter (Fig. 1 and Fig. 2)
1. Unscrew the screw on the battery cover
2. Open the battery cover
3. Install 2 new 1.5V “AAA” batteries with correct polarities (+/-
)
as shown inside the battery compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
Connect the 3.7V rechargeable battery ack to the USB Cable Ada tor.
The charging time for a full charge is about 1 hour. Full charge battery usage Max. 30 mins.
Disconnect the rechargeable battery ack from the USB Cable
Ada ter.
Transmitter
Vehicle
2.4 GHz
Signal Match
Button
Steering
Accelerator Wheel
Trigger
Charging plug
1. Turn on the Vehicle.
2. Hold the Signal Match Button for around 4 second then the Transmitter signal light will flash for 6-7second.
3. After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing.
4. If it cannot complete within 8 seconds, please turn off the Vehicle and re-start the bindingprocess.
5. When the binding process is done, whenever switching the Vehicle on and off, it searches for the code that it memorized, and will only lock on to the
Transmitter signal containing that code.
6. Please turn off the Vehicle and re-start all binding process if changing to another 2.4GHz Transmitter forplaying.
Performance Ti s
1. Do not drive on grass, dirt, sand, dusts, carpet or go through water.
2. Do not drive in windy or rainy weather.
3. Avoid direct impact the Vehicle with obstacles.
4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter
due to leakage of electrolyte from batteries.
5. Remove all batteries from the Vehicle and Transmitter when not in use for long period.
6. Keep fingers, hair and loose clothing away from wheels.
7. The operating range can be affected by a variety of factors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals.
8. Outdoor usage is recommended in order to get optimum control range.
9. Recommend to play the vehicle on a clean and smooth surface.
10.Clean the battery compartment to make sure it is free from dust to prevent poor
contact of batteries
FCC label com liance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RSS-210 Com liance Statement:
This device complies contains licence-exempt transmitter that comply with Innovation Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Declaration of Conformity
The product is in conformity with the requirement of EU Directive 2014/53/EU.
Environmental notes:
The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important
contribution to environmental protection.
Please ask at your local community for the correct collection point.
Dis osal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return
batteries containing harmful substances and all other used batteries. You can hand in your old batteries
at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing
harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury
Frequency band: 2410-2475 MHz
Maximum radio frequency
power transmitted: <0dBm
KIDZTEC TOYS MANUFACTURING LTD.
Room 802, 8/F., Inter-Continental Plaza, 94
Granville Road, TST East, ong Kong. Tel: (852)
27218868 i[email protected]
Made in China http://www.kidztech.net
KT-20190312(EN)
How To Bind
84470
4.
Play on smooth surface to have the optimum
performance
5. Remember to switch OFF the power of the Vehicle after
playing
6. The optimum control range is up to 15moutdoor
2. Use the SteeringWheel to control the Vehicle turning left or right
Turn
Left
Turn
Right
ON/OFF
Backward
Sto
Forward
3. Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward
How To Play
1. Switch ON the Vehicle
Vehicle
