Totemtek AT09 2G User manual

AT09 2G/3G Quick Start Guide
Please Make sure you have download below docs
before you start:
1. AT09 online document support:
https://en.totemtek.com/support/documents/gps-tracker-at09/
--- User manual, configurator, configuration manual.
2. AT09 online video reference:
https://en.totemtek.com/category/blog/video/
Use a pin to push the SIM drawer
out, and put SIM inside the device.
1
Switch on the device
switch to right side.
push yellow button
switch to ‘ON’ side
2
connect device to PC with
configurator via micro USB.
3
Connect GSM and GPS
antenna, put GPS
antenna open to sky.
4
Connect desired IO
port for data collection
and finish the installation
5
PIN 8: color: Red - VCC
PIN 7: color: Black - GND
Power / Ignition detection / cut engine
Emergency button (SOS)
PIN 13: color: Brown- ACC+
PIN 11: color: Orange - DO A (-)
PIN 15: color: black - SOS
PIN 16: color: red - SOS
PIN 1:
PIN 9:
PIN 2:
PIN 10:
Relay
Oil pump
L
O
C
K
A
C
C
O
N
S
T
A
R
T
Storage
battery
/
Fuse
1
color: black with gray strip - ANI 3
color: gray with black strip - ANI 4
color: yellow - ANI 1
color: gray - ANI 2
12V / 24V
ignition detection
remote cut off
Order Number: relay
Maximum length: 3000mm
ANI input for Fuel level detection / voltage collection
Fuel level detection / iButtion identification
DI input for door detection
Negative trigger
Car door with circuit For truck door without circuit
temperature sensor
cable up to 15 meter
iButton reader
camera (picture purpose only) RS485 fuel sensor
Positive trigger
Door positive
trigger connection
Door light
Door switch
12V
Door negative
trigger connection
Door light
Door switch
Section A
www.totemtek.com [email protected]
external door sensor
Red: PWR
Green: GSM
Blue: GPS
LEDs {
Ver: EN 1.0
Date: 2019-10-17
Model:
AT09 2G
eV hicle Trackin Lg ocator
CAUTI ON I: n wa r pd owe Dr 9C 6-V 0V
SOS GND
SOS
DI 3(-)
ACC(+)
DO A (-)
ANI 1
3.3V 1 Wire 1
GND
GND
GND
5V
5V
5V
GND
RS232 TX
RS232 TX
RS232 RX
RS232 RX
RS485 BRS485 A
1 Wire 2
ANI 3
ANI 2 ANI 4
DO D (-)
DI 2 (+)
DI4(-)
GND
VCC
DO B (-)
DO C (-)
MIC MIC
Speaker Speaker
USB USB USB
USB
GSM
GSM
GSM GSM
Section A c
COM1
B
standard USB cable
Configurator
PIN 3:
PIN 12:
color: purple - DO B(-)
color: white- DO C(-)
PIN 4: color: blue - DO D(-)
Cut able Capacitor Fuel sensor
12V
Audio alarm buzzervisible alarm buzzer
12V
PIN 5:
PIN 14:
color: white with black strip - DI2 (+)
PIN 6: color: yellow with green strip - DI4 (-)
color: green - DI3 (-)
Section A
1 wire 1
VCC 3.3
GND
1 wire 2
PIN 1:
PIN 2:
PIN 3:
PIN 4:
RS485 B
GND
RS485 A
VCC 5V
PIN 1:
PIN 2:
PIN 3:
PIN 4:
COM2
Section B
COM 1
12V / 24V

RS232 port can connect with different accessories with variant firmware version.
Accessory will come with the proper connector to plug into AT09 device.
Standard package: AT09 2G/3G device, section A cable, GPS antenna, GSM
antenna, TPMS antenna ( TPMS version only)
433Mhz antenna for AT09
TPMS version only.
all the accessories mentioned here is NOT including in the standard package.
PIN 1:
PIN 5:
PIN 2:
PIN 6:
Speaker
Speaker
MIC
MIC
GND
TX RS232
RX RS232
VCC 5V
PIN 3:
PIN 4:
PIN 7:
PIN 8:
Section B
SpeakerMicrophone
GND
TX RS232
RX RS232
VCC 5V
PIN 1:
PIN 2:
PIN 3:
PIN 4:
COM 2
USB
Connect the TPMS antenna
f if your device is TPMS version
device.
6
GSM TPMS
433Mhz antenna
for tyre sensor.
[email protected]
www.totemtek.com