2008 FJ Cruiser Scheduled Maintenance Guide
60,000 Miles or 72 months
Lubricate propeller shaft (4WD)
4
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter
1
Replace spark plugs
5
Rotate tires
Visually inspect brake linings/drums and brake pads/discs
6
Inspect the following:
__ Automatic transmission fluid
__ Ball joints and dust covers
__ Brake lines and hoses
__ Drive belts
7
__ Drive shaft boots (4WD)
__ Engine coolant
3
__ Engine valve clearance
8
__ Exhaust pipes and mountings
__ Front differential oil (4WD)
__ Fuel lines and connections, fuel tank band
and fuel tank vapor vent system hoses
__ Fuel tank cap gasket
__ Manual transmission oil (4WD)
__ Radiator and condenser
__ Rear differential oil
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil (4WD)
NOTE: When taking your vehicle off-road, refer to ⬙Off-road Daily Maintenance⬙for special
inspections and services.
Additional Maintenance Items for Special Operating Conditions
2
Driving on dirt roads or dusty roads:
Tighten nuts and bolts on chassis
Driving while towing:
Replace automatic transmission fluid
Replace front differential oil (4WD)
Replace manual transmission oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis
DEALER SERVICE VERIFICATION:
DATE:
MILEAGE:
MAINTENANCE LOG
13
1Reset the oil replacement reminder light (⬙MAINT REQD⬙) or the message ⬙OIL MAINTENANCE REQUIRED⬙on the
multi-information display after engine oil replacement.
2Perform these service items only if you drive primarily under the conditions indicated.
3
Refer to ⬙Engine Coolant⬙in the ⬙Explanation of Maintenance Items⬙section in the back of this guide for more information.
4Includes operating on roads which road salt has been applied.
5Required under the terms of the Emission Control Warranty.
6Inspect thickness measurement and disc runout.
7Initial inspection at 60,000 miles/72 months. Inspect every 15,000 miles/18 months thereafter.
8Check for tappet noise and engine vibration and adjust if necessary.