2008 Tundra Scheduled Maintenance Guide
60,000 Miles or 72 months
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter
1
Replace spark plugs
5
Rotate tires
Visually inspect brake linings/drums and brake pads/discs
4
Inspect the following:
__ Automatic transmission fluid
__ Ball joints and dust covers
__ Brake lines and hoses
__ Drive belts
6
__ Drive shaft boots (4WD)
__ Engine coolant
3
__ Engine valve clearance
7
__ Exhaust pipes and mountings
__ Front differential oil (4WD)
__ Fuel lines and connections, fuel tank band
and fuel tank vapor vent system hoses
__ Fuel tank cap gasket
__ Radiator and condenser
__ Rear differential oil
__ Steering gear box
__ Steering linkage and boots
__ Transfer case oil (4WD)
Additional Maintenance Items for Special Operating Conditions
2
Driving on dirt roads or dusty roads:
Tighten nuts and bolts on chassis
Driving while towing:
Replace automatic transmission fluid
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis
DEALER SERVICE VERIFICATION:
DATE:
MILEAGE:
MAINTENANCE LOG
13
1Reset the oil replacement reminder light (⬙MAINT REQD⬙) or the message ⬙OIL MAINTENANCE REQUIRED⬙on the
multi-information display after engine oil replacement.
2Perform these service items only if you drive primarily under the conditions indicated.
3
Refer to ⬙Engine Coolant⬙in the ⬙Explanation of Maintenance Items⬙section in the back of this guide for more information.
4Inspect thickness measurement and disc runout.
51GR-FE engine. Maintenance services of spark plugs are required under the terms of the Emissions Control Warranty.
6Initial inspection at 60,000 miles/72 months. Inspect every 15,000 miles/18 months thereafter.
7Check for tappet noise and engine vibration and adjust if necessary, 1GR-FE and 2UZ-FE engines only.