TP-Link TL-WR841N User manual

CONTENTS
English ........................................................... 1
Français........................................................ 15

1
English
Quick Installation Guide

2
English
1. Power off your modem.
2. Connect the WAN port on your router to the modem’s LAN port with an
Ethernet cable.
3. Connect your computer to one of the LAN ports labeled 1~4 on the router
with an Ethernet cable.
4. Power on the modem and wait for one minute.
5. Plug the provided Power Adapter into the POWER jack on the back of the
router and the other end to a standard electrical wall socket. Press the
ON/OFF button to power on the router.
1. Insert the TP-LINK Resource CD into the CD-ROM drive.

1
1
Hardware Connection
Please confirm that the WIFI switch is ON so that client devices
can connect to the router wirelessly.
2
2
Configuration for Windows with Setup Wizard
Note
If you are using a MAC/Linux or a Windows computer without a
CD drive to run the mini CD, please refer to Appendix 1 fo
r
configuration.
Note

3
English
2. Select TL-WR841N and click Easy Setup Assistant.
3. Choose your language from the pull-down list. Then click START.
English

4
English
4. After confirming the hardware connection and the status of LEDs, click
NEXT to continue.
5. After the connectivity is checked successfully, please click NEXT.
English

5
English
6. Select the connection type your ISP provides and click NEXT. Here we take
Dynamic IP for example.
7. In most cases, there is no need to clone MAC address if you have rebooted
the modem with the new router.
English

6
English
8. You can rename your wireless network on this page. The default wireless
name is TP-LINK_XXXXXX. Click NEXT to continue.
9. You are recommended to select Most Security (WPA2-PSK) to secure your
wireless network.
The router is pre-encrypted. The default wireless password,
same as the PIN code, is printed on the label at the bottom of the
router.
Note
English

7
English
10. After confirming the configurations, click NEXT to continue.
11. After the configuration is completed successfully, please click NEXT.
You can save these settings in a text file on your desktop. If you
forget the Network Security Key, you can check the Route
r
Settings.txt.
Note
English

8
English
12. If your client devices support WPS(Wi-Fi Protected Setup), you can add
your device to the network by pushing the WPS button. Then click NEXT.
13. Click FINISH to complete the setup.
You can click WEB management interface for more advanced
settings.
Note
English