Trac Vac DS200 User manual

5-16-11
DS200
Discharge Shield
Instruction Manual
Midwest Equipment Mfg.
5225 Serum Plant Road
Thorntown, IN 46071

1
D
L
H
G
8
B
A
F
2
I
J
M
E
C
K
G
9
9
93
7
4
10
6
5
5
12
11
5
4
4
9
N
13
13
O
DS200 PARTS BEAK DOWN
PART NO. DESCRIPTIONKEY
A DS11010 Pivot Ass'y
B DS11021 Rubber Flap
DS11030C Flap Support
D DS11040 Linkage
E
F
G
3/8" Ball Joint
I
H
32108
65018 Spring
Mount Angle
DS11060
J
DS21030 Pivot Tube, RH
K
DS21040 Pivot Tube, LH
L
DS20010
M 34241 Hand Grip
Pivot Pin
DS21050 Mount Ass'y
DS11080 Control Handle
N DS20020 Short Mount Angle
O DS20021 Tall Mount Angle
KEY QTYDESCRIPTION
5/16"-18 Whizlock Nut
Hairpin Cotter
5/16"-18 Locknut
5/16" USS Flatwasher
2
7
6
4
5
3
2
8
74 4
1/4"-20 Locknut
1/4"-20 X 1" HHC
5/16"-18 x 1 1/2" HHC
9
10 5/16-18 X 3/4" HHC 5
1
1
3
5/16-18 X 1 1/4" HHC 1
11 5/16-18 X 1" HHC 2
12 56107 3/16" Washer 1
13 1/4" FLW 4

2
The Diverter
Mounting Instructions
Part No. DS200
STEP 1:
Bolt the Diverter Shield and Support to the
Pivot Assembly as shown in Fig. A.
Fig. A
STEP 2:
Bolt the angle mount flange to the control
handle assembly as illustrated in Fig. B
with hardware provided and tighten. Attach
the Diverter with the pivot pin. Hold the
Diverter up to the deck. Make sure the flap
flap on the Diverter covers the front of the
discharge opening. Mark and drill the hole
hole locations on the horizontal mount
surface on the deck that align with the holes
in the angle mount flange. Attach assembly
to deck with hardware provided and tighten
all hardware. Trim flap to fit if needed.
Periodically check all hardware for tightness.
Note: A shorter mount angle and a a short
angle with a taller rise are included for
decks with smaller surface area.
Fig. B
Fig. C

3
TRAC VAC WARRANTY POLICY
Midwest Equipment Mfg. will repair or replace, free of charge, any part, or parts that are defective in material
or workmanship or both for a period of one year residential use, and 90 day’s for commercial and rental use.
The purchaser will pay transportation charges on parts submitted for replacement under warranty. For
warranty service, contact your local dealer from whom the unit was purchased. There are no other express or
implied warranties. Some states do not allow limitations on how long an implied warranty lasts, and some
states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other
rights, which vary from state to state.
MIDWEST EQUIPMENT MFG .
5225 Serum Plant Rd.
Thorntown, IN 46071
Phone: 1-800-Trac-Vac
Web Page: www.trac-vac.com E-Mail: [e-mail]