TrainModules NaWi 62945 User manual

NaWi©- 8 channel hub
User guide
62945
Draft for discussion and testing only!

1
© 2010 BioDigit Ltd.
All rights reserved. Multiplication of the document or publication of its content
in any form (including electronic and mechanical implementation) is prohibited
without the written approval of BioDigit ltd.
Safety precautions
You must always observe the technical specifications indicated in the
specifications when using the device. Please always take care of the
environment when putting the device into operation and protect the device
from moisture and direct sunshine.
You may need a soldering iron during installation or putting the device into
operation. Please be careful when executing these operations.
Technical parameters:
Dimensions: 85x50 mm
Idle mode current consumption: 20 mA
Max. current consumption: 120 mA
Operating frequency: ISM - 2,4GHz DSSS (certified)
Number of selectable channels: 70 + 2 service channel
Wireless standard: NaWi© interface
Wireless range: ~ 100m
Case and interface review

2
Mode button: Used for channel selection.
Channels (CH1-CH8): Push buttons and status indicator LEDs.
Indicated statuses:
- Dark: The slot is free, no communication.
- Blinking: The slot is waiting for controller synchronization.
- Light with flashes: The slot is in use, proper communication with the
controller.
LocoNet interface: The common interface to the command station. Use the
LocoNet B or LocoNet T socket on the command station to connect the hub.
Changing the radio channel
1. Press the Mode button at least one second.
2. The dot, after the channel number on the display will be turned off.
3. Press the mode button, to change the radio channel (incremental)
4. One second after the button is released, the hub will reboot.
Synchronizing with NaWi wireless controller
1. Check the wireless hub address. Make sure, the controller and the
hub is on same channel.
2. Press the push button of selected slot on the wireless Hub.
3. The pushed channel will now blinking. That means: Waiting for
controller.
4. On the wireless controller, hold the "Shift" key and press the Power
button simultaneously on the wireless controller.
5. The controller now in Locomotive mode (Lxxx on display)
6. Synchronizing is completed. The controller is registered on the Hub.
TrainModules ®: BioDigit Ltd.
NaWi®: BioDigit Ltd.
LocoNet®: Digitrax Inc.
NMRA DCC: National Model Railroad Association

3