Trans-Tek LS802-GP User manual

When symbol shown on
the LCD, indicating pair-up
succeed. Then the device
will turn off automatically.
Quick Start
Guide
Pro Cellular Blood Pressure
Monitor LS802-GP
Insert four AA batteries into
the back of the scale. Once
inserted, the scale will perform an
initial secure pairing with the
mobile network.
1
3
4
6
8
2
5
7
Vital Remote Links Body Scale
Wrap the cuff around your arm,
make sure the cuff edge 1 inch
(2-3 cm) above the elbow.
Don't make it too tight—allow a
finger to fit between the cuff and
your arm.
Lay your arm on a table with
your palm facing up. The cuff
should be at the same height
as your heart.
The whole LCD display, then
the symbol and will
be shown alternatively on the
LCD, indicating pair-up is
proceeding.
Plug the connector on cuff
tube into the device.
Press the " ” button to
turn on the monitor, remain
still until the cuff deflates
completely.
Display and save the results.
10
9
Data transmission after
measurement.
The symbol blinks
on the LCD.
3.If the data is successfully
ransmitted, the symbol will
disappear and the LCD will display
and then the device will turn off.
Transmission in progress
Transmission successful
2~3cm

If any abnormality arises during use, please check the following points:
NOTE: If the product still does not work, contact Transtek Customer Service. Under no
circumstance should you disassemble or attempt to repair the unit by yourself.
PROBLEM SYMPTOM CHECK THIS REMEDY
No power
Low Battery
Error
message
Display can not
light up.
Batteries are exhausted. Replace with new batteries.
Insert the batteries correctly.
Replace with new batteries.
Batteries are inserted
incorrectly.
Lo & shows The battery is too low.
E 1 shows
E 3 shows
E 4 shows The measurement failed.
Adapter is inserted
incorrectly.
Insert the AC adapter correctly.
The cuff is not wrapped
or wrapped incorrectly,
or the cuff air plug is loose.
Refasten the cuff and insert
air tube plug correctly then
measure again.
Relax for 5 minutes. and then
keep still, measure again.
Relax for 5 minutes and
measure again.
Pulse is not detected
during measuring.
Loosen the clothing on the arm
and then measure again.
Warning
message
Relax for a moment. Refasten
the cuff and then measure again.
If the problem persists, contact
your physician.
out shows Out of measurement
range
EExx shows Hardware error
(xx can be some digital
symbol,such as 1, 2, etc.)
Turn off monitor and measure
again. If EEx still appears on the
display, please contact the
retailer or our customer service.
E5 shows Failed to communicate
with the server
Try a place with better signal,
or contact customer service
E6 shows Radio communication
failure
Contact customer service
Excessive body motion
(such as shaking of the
arm with the cuff on)
or weak Pulse is detected
during measuring.
E 2 or
shows