TRIBU 06040-x User manual

FORUM LOUNGER
HEADREST BATYLINE REPLACEMENT
06040-x
FLBR02 - 20-06-2016
Tribù nv
Langendijkstraat 5a
3690 Zutendaal
BELGIUM
www.tribu.com
[email protected]
Slide the plastic tube from the Batyline and slide it into the new Batyline.
Slide the new Batyline + Plastic tube back into the headrest.
Use the clamp like in step 4 to make it easier.
A. Carefully place the frame over the headrest.
B. Fix the screws from step 2.
Use a clamp to put pressure on the headrest and Batyline. Put the 2 reinforcements
back into place and x with the screws from step 3B.
5 7
6
OLD
NEW

CONTENT ASSEMBLY INSTRUCTIONS
1 x
Replacement Batyline Headrest
Make sure the lounger is in the at position.
Carefully put it upside down onto a protective surface.
Unscrew the following screws
A. 2 Screws at the hinge location
B. 2 Screws too loosen the headrest support
A. Carefully lift the frame from the bed part.
B. Unscrew the screws that x the reinforcements and take away the reinforcements.
Put pressure on the welded reinforcement with a clamp. Then remove the plastic
parts and slide out the Batyline.
1
2
3
4
OK
NOT OK
A.
A.
B.
B.