Tricity Bendix TIRSS2211 User manual

Instruction Manual
Steam Iron
TIRSS2211

Please follow all the precautions listed below for safety and to reduce
the risk of re, injury or electrical shock.
Read all the instructions before operating the iron and keep them for future refer-
ence. If you pass the product on to a third party, include these instructions.
Unplug the iron from the mains supply when not in use, and before emptying,
lling, or cleaning.
Do not touch the soleplate of the iron if it is hot.
Always hold the appliance by the handle.
Keep the appliance well away from surfaces and objects that can be damaged by
heat.
Ensure there is adequate room to operate the iron.
Ensure that the iron cannot fall into water.
Do not immerse the connecting cord in any liquid.
Do not let the connecting cord overhang the edge of the work surface or allow it to
touch hot surfaces or sources of heat or ame.
If any part of this appliance is damaged or malfunctions in any way, or the connect-
ing cord or mains plug is broken do not continue to use it. Seek expert assistance.
Do not use the iron if the cord insulation or conductors are visibly damaged.
Do not use the iron if water is leaking from it.
Do not leave the iron face down at any time. Stand it upright on its heel, on a level
heatproof surface.
Do not use outdoors or in damp or wet conditions.
When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
Do not use this iron for professional laundry services.
Do NOT use this appliance for any purpose not covered by the instructions.
Use caution when turning the iron upside down, there may be hot water in the
water tank.
Use only with a purpose-built ironing board.
Observe all ironing instructions and ironing temperature dot settings given by the
garment manufacturer.These are normally on a label or labels inside the garment.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of this appli-
ance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Parents must warn children not to touch hot appliance parts.
The iron must not be left unattended while it is connected to the supply
mains.
Do not use this iron if it is dropped, has visible signs of damage or is not
watertight.
Burns can occur from touching hot metal parts, hot water or steam. Exercise
care when handling this appliance!
ELECTRICAL INFORMATION
Before using this appliance ensure that the voltage of your electricity supply is the
same as that indicated on the appliance.
The means of disconnecting this appliance from the mains supply is the mains plug.
This should be unobstructed and readily operable at all times
This appliance must be earthed
Important Safety Instructions

Know Your Iron
Features and controls
max
A
B
C
D
EF
G
H
I
N
J
K
L
M
A: Soleplate
B: Spray nozzle
C: Filler cap
D: Steam control
E: Spray button
F: Shot of steam button
G: Safety sleeve
H: Power cord
I: Power light
J:Temperature knob
K: Water reservoir
L: Self-Clean button
M: Maximum lling level
N: Filling Cup

Unpacking Your Iron
Unpack the iron carefully. If you dispose of the packaging, do so having regard to
any recycling regulations in your area.
The packaging contains:
OneTricity Steam Iron
One ller cup
If any item is missing or damaged: please contact theTesco store where you
purchased the item, or your nearestTesco store. Please have your receipt ready
when you call.
Important Special Features of Your Iron
Soleplate: The soleplate of the iron is polished. To protect the nish do not use
abrasives to clean the iron and avoid running the iron over hard metal surfaces.
Anti-Scale System: A special resin lter inside the water reservoir softens the wa-
ter and prevents scale build-up in the plate. The resin lter is permanent and does
not need replacing.
Use tap water only. Distilled and/or demineralised water makes the anti-calc system
ineective by altering its characteristics. Do not use chemical additives, scented sub-
stances or decalciers. Failure to comply may invalidate the guarantee.
Anti-Drip System: Always iron delicate fabrics at low temperatures. At these low
temperatures the soleplate may cool to the point where no steam comes out, but
drops of boiling water can still escape which can leave marks or stains. If this occurs,
the Anti-drip system automatically activates to prevent vapourization, so that you
can iron the most delicate fabrics without risk of spoiling or staining them.
Ironing Temperatures
Check the ironing instructions attached to the article (they are on a label showing a
symbol of an iron). Always follow these ironing instructions.The indications on the
iron’s temperature dial and the table below will help you.
If there are no ironing instructions but you know the fabric, then use the table
below.The table is valid only for the actual materials and does not take account of
any nish applied to the fabric. Textiles to which a nish has been applied (wrinkle
relief, printedT shirts etc.) should be ironed at lower temperatures.
If the fabric contains mixed bres, select the lowest ironing temperature of the
composition, e.g. iron a 60% polyester /40% cotton mix at the temperature
indicated for polyester.
Do not iron
Synthetics. Set Iron to LOW ( • )
Wool, Silk. Set Iron to MEDIUM ( • • )
Cotton, Linen. Set Iron to HIGH ( • • • )
The iron heats up quicker than it cools down. Sort fabrics to be ironed into groups
according to temperature; wool with wool, cotton with cotton, etc. Start by ironing
articles requiring low temperature settings and progress to higher ones.
Note: Do not iron garments that are dirty or stained.The heat may set the stain.
Pure (100%) wool fabrics may be pressed with the iron set to a steam position and
the garment protected by a dry cloth.
Preliminaries
Before You Start

Filling the Iron
DO NOT use water containing softeners, perfumes or additives as these may
damage the iron irreparably.
Unplug the iron from the mains. Set the Steam Control to OFF.
Lift up the water ller cap. Be careful not to use excessive force or you may damage
the hinge.
Fill carefully with fresh water
using the supplied ller cup.
Do not ll the iron above the
MAX mark indicated on the side
of the iron.
Close the cap
Operation
Ensure the mains socket is switched o at the wall and the Steam Control is OFF.
Fill the iron with water as described above.
Place the iron on its heel on the ironing board rest and connect the power cord to
the wall socket.
Switch on the power.The pilot light will illuminate.
Select the correct temperature.
Turn clockwise to increase
and anti clockwise to reduce
temperature.
The pilot light will turn‘OFF’when the indicated setting reaches the correct
temperature.The iron is now ready for use.
During use the indicator will come on and o as the thermostat maintains the iron
at the correct temperature setting.
Note: Some parts have been lightly greased and the iron might smoke slightly when
switched on for the rst time. After a short while, this will cease.
Before using your iron for the rst time: Pass the iron over a clean cotton cloth to
remove any residue.
Steam Ironing
Steam Ironing should be carried out at the
highest settings on the temperature dial.
The quantity of steam is regulated by the
Steam Control. Move the steam control to a suitable position depending on the
amount of steam required and the ironing temperature.
Warning: the iron gives o steam continuously only if you hold the iron horizontally.
You can stop the continuous steam by placing the iron in a vertical position or by
moving the steam selector to 0.
Basic Operation
Getting Started
INCREASE

Shot of Steam Button
This feature may be used during steam or
dry ironing but only when the iron is at
highest settings.
Press the Shot of Steam button to release
a surge of steam. You may need to press
the button a few times to prime the
system. Wait a few seconds for the steam
to penetrate the fabric before pressing the
button again.
Excessive use of this feature will cause
the iron to cool, and the pilot light will illuminate. If this happens, wait for the pilot
light to go out before using the feature again.
Vertical Shot of Steam
Set the iron to its highest temperature and
wait for the pilot light to go out.
Set the iron vertical. Hold the iron away
from you and 15 – 30 centimetres from the
garment.
Press the Shot of Steam Button once. Steam
penetrates into the garment removing the
wrinkles.
For stubborn wrinkles: set the iron back on
its stand and wait a few seconds. Repeat the
procedure once more. Most wrinkles can be removed within three presses.
Warning: DO NOT allow anyone to come near you during this process.
NEVER allow steam to get anywhere near your body or clothing or apply steam to
clothes or fabrics that are being worn by human or pets. DANGER OF SCALDING.
Hold the iron facing away from you at all times. DO NOT OVERREACH or operate
the iron while standing on a ladder etc.
Spray Button
Press the spray button to spray water on
the material. It may be used for steam or
dry ironing.
Note: To avoid staining, do not use the
spray on silk or synthetics, and be careful
when you iron delicate fabrics.
Note: For Spray and Shot of Steam
functions to operate, the water tank
must be at least one-quarter full.
If these features stop working place the iron on its stand and ll the water tank.
During Ironing:
In between operations always stand the iron on its heel.
NEVER leave the iron face down.
During use, the anti drip system may emit a loud clicking sound, particularly when
the iron heats up or cools down. This is normal and indicates that the system is
functioning correctly.
Special Features
Advanced Operation

After you have nished ironing:
Set the steam control to minimum.
Switch the iron o at the mains and unplug.
Stand the iron on its heel and let the iron cool down fully.
When the iron is cool:
Invert the iron, open the ller and
pour away the excess water from
the tank.
When pouring away the water,
gently shake the iron to remove
any loose particles from the tank.
Care and Cleaning
Unplug the iron from the mains and allow it to cool down fully.
Cleaning: To remove starch or other deposits from the soleplate, apply a small
amount of mild cleaner to a damp cloth, forming a paste on the cloth. Gently rub
the soleplate, then wipe with a moist cloth.
The body of the iron may now be cleaned with a barely damp cloth and then dried
thoroughly. Do not wet the appliance body, cord or mains plug.
CAUTION: Never use scouring pads, abrasives or harsh cleaners on the iron body or
the soleplate.
Self Cleaning
This operation removes scale and impurities from the iron.We recommend using it
every 10-15days.
Fill the reservoir to the MAX level. Set the steam control to“O”.
Set the temperature knob to the highest temperature.
Switch the iron on and and wait for the power light to turn o.
Unplug the iron from the mains.
Hold the iron horizontally over the sink.
Press and hold the Self Clean button.
Steam and boiling water will drain from
the holes on the soleplate washing away
any deposits that have built up. Gently
move the iron back and forth until the
water tank is empty.
When Self-Cleaning is complete, release the Self-Clean button. Rest your iron on its
heel rest and allow to fully cool down.Wipe the soleplate with a cold damp cloth.
and store it safely.
Care, Cleaning and Storage
After Use
max

Te sco Stores Ltd, Delamare Road,
Cheshunt, Herts, EN8 9SL
Conclusion
Storage
When not in use the iron should be securely stored out of the reach of children.
Store the iron on its heel. Do NOT store the iron on its soleplate or you may damage
the nish.
loosely loop the cord without kinking or straining it.
Do not wrap the cord tightly around the body of the iron.
After storage, always ensure the cord is fully unwound and and kinks are straight-
ened out to prevent internal damage to the cord.
Warranty
YourTricity iron is covered by a warranty for 12 months from the date of purchase. If
a fault develops during this period, please return the unit to your nearestTesco store
together with the original receipt as proof of purchase.This warranty in no way
aects your consumer rights.
Specications
Voltage Rating: 220 -240V AC, 50Hz
Power Consumption: 2000-2200W
NetWeight: XX kg
UK: Waste electrical products should not be disposed of with household
waste. Separate disposal facilities exist, for your nearest facilities. See
www.recycle-more.co.uk or in-store for details.
ROI: Produced after 13th August 2005.Waste electrical products should
not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.