Teaching Additional
FOB Transmitters
Programming key fobs to this device requires the use of the TriMark Keypad
1. Hold the [5 / 6] button (or [3] for doorbell versions) of the keypad for 5 seconds. The key-
pad will beep and the backlight will flash.
2. Enter your authority code. The buzzer stays on until the next step if the authority code is
correct.
3. Hold [9 / 0] button (or [DOORBELL] for doorbell versions) for 5 seconds. A double-beep
plays.
4. The receiver module is now in e-FOB learn mode.
5. Press and hold the LOCK (or ENTRY LOCK) button of each transmitter to be trained, one
at a time. Press and hold the button for 5 seconds for the first key fob, and for 2 seconds
on each additional key fob. You must wait three seconds between each key fob.
6. After 60 seconds of e-FOB button inactivity, or by simply pressing any key on the keypad,
4 beeps will sound and the module will return to normal operation.
Notes:
If you place the system in learn mode and teach nothing, the system will exit in 60 sec-
onds and nothing will change.
All previous transmitters are erased if a transmitter is taught during a programming
session, so all transmitters must be taught in the same session to retain functionality.
This device complies with Part 15 of FCC rules. Operation is subject to the following condi-
tions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this device.
TriMark CAN Vehicle RF Receiver 25048-01
