Tripp Lite U457-1M2-NVME-L User manual

1
1111 W. 35th Street, Chicago, IL 60609 USA
tripplite.com/support
Copyright © 2022 Tripp Lite. All rights reserved.
Owner’s Manual
WARRANTY REGISTRATION
Register your product today and be automatically entered
to win an ISOBAR®surge protector in our monthly drawing!
tripplite.com/warranty
USB 3.2 Gen 2 Type-C®to M.2
NVMe SSD Gaming Enclosure
Adapter with LEDs
Model: U457-1M2-NVME-L
USB Type-C and USB-C are registered trademarks
of USB Implementers Forum
Español 13 • Français 24
Русский 35 • Deutsch 46

2
• Read,writeortransferlestoandfromyour
computer by adding the speed of an M.2 NVMe
SSD
• Supports M.2 drive sizes of 2230, 2242, 2260 and
2280
• Supports USB 3.2 Gen 2 data transfer rates up to
10 Gbps and is backwards compatible with
USB 3.0, 2.0 and 1.1
• UASP compatible for up to 70% faster read and
40% faster write performance
Product Features

3
• U420-003-G2 USB 3.2 Gen2 Type-C (10 Gbps) to
Type-C Cable, 3 ft. (0.9m)
• U457-1M2-NVME-L
• USB 3.2 Gen 2 (10 Gbps) Type-C Cable (M/M),
1.5 ft. (0.45m)
• Mounting Hardware
• Mini Screwdriver
• Silica Gel Plug
• Heat-Dissipating Silicone Pad
• Quick Start Guide
Optional Accessories
Package Contents

4
Notes:
• HDD/SSD drives are sensitive to static electricity and must
be handled properly to prevent the risk of data loss. Always
handle your HDD/SSD drive with caution by wearing an
anti-static strap (such as Tripp Lite’s P999-000) when
transporting it or by touching a grounded metal surface to
discharge yourself of static electricity prior to picking up the
drive.
• When disconnecting the drive, make sure to go through
the proper disconnection steps of your operating system.
Removing the drive with improper disconnection can result
in data loss or corruption.
1. Pull out the hard drive tray and assemble the
included silica gel plug into the SSD hole.
Standard Installation

5
Standard Installation
2. Place the M.2 SSD onto the card slot and rotate
the silica gel plug to lock the SSD into place.

6
Standard Installation
3.Peelo󰀨thelmoftheblueheat-dissipating
silicone pad, paste the pad on the SSD, then
paste the heat-conducting copper sheet on the
pad.

7
Standard Installation
4. Secure the tray in place with the included screws.
Optionally, paste the faceplate over the LEDs
with the acrylic tape side of the plate.

8
Standard Installation
5. Connect the included USB-C 3.2 Gen 2 cable to
the USB-C port on the adapter and the USB-C
port on your computer.
Note: A partitioned SSD will be recognized as “New
Drive” after being connected to the computer and can
read/write directly. A new SSD will need to be partitioned
before it is recognized by the computer.

9
Specications
Input USB-C (Female)
SSD Type B+M Key (SATA) /
M Key / B+M Key (NVME)
SSD Size 2230, 2242, 2260, 2280
USBSpecication USB 3.2 Gen 2 (10 Gbps)
LED Description (x1) Power/Data = Blue;
RGB alternating
Power Source Hub Powered
Material Aluminum
Operating System
Compatibility
Windows, Mac, Linux
Operating Temperature
Range
50° to 158°F (10° to 70°C)
Storage Temperature
Range
32° to 149°F (0° to 65°C)
Relative Humidity
Range
10% to 80% RH
Unit Dimensions
[H x W x D]
0.78 x 1.81 x 4.33 in.
(20 x 46 x 110 mm)

10
Warranty and
Product Registration
1-Year Limited Warranty
Seller warrants this product, if used in accordance with all
applicable instructions, to be free from original defects in
material and workmanship for a period of one (1) year from
the date of initial purchase. If the product should prove
defective in material or workmanship within that period,
Seller will repair or replace the product, at its sole discretion.
THIS WARRANTY DOES NOT APPLY TO NORMAL
WEAR OR TO DAMAGE RESULTING FROM ACCIDENT,
MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO
EXPRESS WARRANTIES OTHER THAN THE WARRANTY
EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE
EXTENT PROHIBITED BY APPLICABLE LAW, ALL
IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES
OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN
DURATION TO THE WARRANTY PERIOD SET FORTH
ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES
ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES.
(Some states do not allow limitations on how long an implied
warranty lasts, and some states do not allow the exclusion
or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This
warrantygivesyouspeciclegalrights,andyoumayhave
other rights which vary from jurisdiction to jurisdiction.)
WARNING: The individual user should take care to
determine prior to use whether this device is suitable,
adequate or safe for the use intended. Since individual
applications are subject to great variation, the manufacturer
makes no representation or warranty as to the suitability or
tnessofthesedevicesforanyspecicapplication.

11
Warranty and
Product Registration
PRODUCT REGISTRATION
Visit tripplite.com/warranty today to register your new
Tripp Lite product. You’ll be automatically entered into a
drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some
restrictions apply. See website for details.
WEEE Compliance Information for Tripp Lite
Customers and Recyclers (European Union)
Under the Waste Electrical and Electronic
Equipment (WEEE) Directive and implementing
regulations, when customers buy new electrical
and electronic equipment from Tripp Lite, they are
entitled to:
• Send old equipment for recycling on a one-for-one,
like-for-like basis (this varies depending on the
country)
• Send the new equipment back for recycling when
this ultimately becomes waste
Use of this equipment in life support applications where
failure of this equipment can reasonably be expected
to cause the failure of the life support equipment or
tosignicantlya󰀨ectitssafetyore󰀨ectivenessisnot
recommended.
Tripp Lite has a policy of continuous improvement.
Specicationsaresubjecttochangewithoutnotice.Photos
andillustrationsmaydi󰀨erslightlyfromactualproducts.

12
1111 W. 35th Street, Chicago, IL 60609 USA
tripplite.com/support
22-02-101 934122_RevA

13
1111 W. 35th Street, Chicago, IL 60609, EE. UU.
tripplite.com/support
Copyright © 2022 Tripp Lite. Todos los derechos reservados.
Manual del Propietario
Adaptador de Gabinete de
Juegos USB 3.2 Gen 2 Type-C®
a SSD NVMe M.2 con LEDs
Modelo: U457-1M2-NVME-L
USB Type-C y USB-C son marcas comerciales registradas
del USB Implementers Forum
English 1 • Français 24
Русский 35 • Deutsch 46

14
• Lea,escribaotranseraarchivosaydesdesu
computadoraagregandolavelocidaddeunSSD
NVMe M.2
• CompatiblecontamañosdeunidadM.2de2230,
2242, 2260 y 2280
• Compatible con velocidades de transferencia
dedatosUSB3.2Gen2hasta10Gbpsyes
compatible con las versiones anteriores de
USB3.0,2.0y1.1
• CompatibleconUASPparaunrendimientode
lectura70%másrápidoydeescritura40%más
rápido
Características del Producto

15
• U420-003-G2–CableUSB3.2Gen2Type-C
(10Gbps)aType-C,0.9m[3pies]
• U457-1M2-NVME-L
• CableUSB3.2Gen2(10Gbps)Type-C(M/M),
0.45m[1.5pies]
• Accesorios de Instalación
• MiniDestornillador
• TapóndeGeldeSílice
• AlmohadilladeSilicónDisipadoradeCalor
• GuíadeInicioRápido
Accesorios Opcionales
Contenido del Empaque

16
Notas:
• Las unidades HDD y SSD son sensibles a la electricidad
estática y deben manipularse con cuidado para evitar el
riesgo de pérdida de datos. Manipule siempre su HDD/
SSD con la precaución de usar una banda antiestática
(como la P999-000 Tripp Lite) al transportarla o tocando
una supercie metálica aterrizada para descargar la
electricidad estática antes de tomar la unidad.
• Al desconectar la unidad, asegúrese de seguir los pasos
de desconexión adecuados de su sistema operativo.
Retirar la unidad con una desconexión inadecuada puede
dar lugar a la pérdida o corrupción de los datos.
1. Jalelabandejadeldiscoduroyensambleel
tapóndegeldesíliceincluidoeneloriciodel
SSD.
Instalación Estándar

17
Instalación Estándar
2. ColoqueelSSDM.2enlaranuraparatarjeta
ygireeltapóndegeldesíliceparaasegurarel
SSDensusitio.

18
Instalación Estándar
3.Despeguelapelículadelaalmohadillaazulde
silicóndisipadoradecalor,peguelaalmohadilla
enelSSDyluegopeguelaláminadecobreque
conducealcalorenlaalmohadilla.

19
Instalación Estándar
4.Asegurelabandejaensulugarconlostornillos
incluidos.Comoopción,peguelaplacafrontal
sobrelosLEDsconelladodelacintadeacrílico
de la placa.

20
Instalación Estándar
5.ConecteelcableUSB3.2Gen2incluidoal
puertoUSB-CeneladaptadoryelpuertoUSB-C
ensucomputadora.
Nota: Un SSD con partición será reconocido
como "Nueva Unidad" después de conectarse a la
computadora y se puede leer/escribir directamente. Será
necesario hacer partición de un nuevo SSD antes de que
sea reconocido por la computadora.