Triumph Street Triple R Installation manual

Street Triple R Additional Information
1 of 4
STREET TRIPLE R
ADDITIONAL INFORMATION
Part Number: 3852802 06/08

2 of 4
Street Triple R Additional Information
Street Triple R
This handbook addendum contains
information for the ignition key, suspension,
brakes, tyres and specifications for the
Street Triple R and must be read in
conjunction with the accompanying owner's
handbook.
All other details are as described for the
Street Triple in the accompanying owner's
handbook.
Always keep this addendum with the owner's
handbook, store them with the motorcycle
and refer to them whenever necessary.
Ignition Key
1. Key number tag
2. Third key for alarm system
For Street Triple R there is a third key that
does not have a fob. This is for the accessory
alarm system.
Suspension Settings -
Street Triple R Only
The standard suspension settings provide a
comfortable ride and good handling
characteristics for general, solo riding. The
sport suspension settings provide
sport-oriented handling characteristics with a
slight sacrifice to rider comfort. The chart on
the next page shows suggested settings for
the front and rear suspension.
Note:
• The suspension setting chart is
only a guide for the Street Triple R,
not any other model.
• Setting requirements may vary for
rider weight and personal
preferences.
1
2
ceom
Warning
Ensure that the correct balance between
front and rear suspension is maintained.
Suspension imbalance could significantly
change handling characteristics leading to
loss of control and an accident. Refer to the
chart below for further information or
consult your dealer.
Warning
Ensure that the adjusters are set to the
same settings on both forks. Settings which
vary from left to right could significantly
change handling characteristics leading to
loss of control and an accident.

3 of 4
Street Triple R Additional Information
Suspension Setting Chart
The method to adjust the front and rear
suspension is the same as described for the
Daytona 675 in the accompanying
handbook, with the exception of the
following:
• Front and rear suspension rebound
damping - count the number of
clicks out from the fully screwed in
position;
• Front and rear suspension
compression damping - count the
number of clicks out from the fully
screwed in position.
Note:
• The motorcycle is delivered from
the factory with the suspension set
at the standard settings, as shown
in the table above.
Brakes
Brake Fluid Level Inspection and
Adjustment
The inspection and adjustment of the brake
fluid level in the reservoirs is the same as the
Daytona 675. Refer to the Maintenance
section in the accompanying handbook.
LOADING FRONT REAR
Spring
Pre-Load¹
Rebound
Damping²
Compression
Damping²
Rebound
Damping²
Compression
Damping²
Solo
Riding
Standard 7 4 4 8 8
Softer 7 6 6 10 10
Sport 7 2 2 6 6
Rider and Passenger 7 4 4 8 4
¹ Number of turns out from the fully screwed in position.
² Number of clicks out from the fully screwed in position.
Warning
The rear suspension unit spring pre-load is
not rider adjustable.
Any attempt to adjust the spring pre-load
could result in a dangerous riding
condition leading to loss of control and an
accident.

4 of 4
Street Triple R Additional Information
Tyre Options
Tyre Pressures Specifications
The specifications for the Street Triple R are
the same as the Street Triple details given in
the accompanying handbook with the
exception of the following listed below.
Option Front Rear Front Size Rear Size
1DunlopSportmax
Qualifier
Dunlop Sportmax
Qualifier
120/70 ZR 17 180/55 ZR 17
2 Bridgestone BT015 G Bridgestone BT015 E
Warning
Use the recommended tyre options ONLY in the combinations given. Do not mix tyres from
different manufacturers or mix different specification tyres from the same manufacturers as
this may result in loss motorcycle control and an accident.
Front 2.35 Bar (34 lb/in²)
Rear 2.90 Bar (42 lb/in²)
Warning
Incorrect tyre inflation will cause abnormal
tread wear and instability problems that
may lead to loss of control and an accident.
Under-inflation may result in the tyre
slipping on, or coming off the rim. Over
inflation will cause instability and
accelerated tread wear.
Both conditions are dangerous as they may
cause loss of control leading to an accident.
Dimensions
Overall Length. . . 2,030 mm (79.9 in)
Overall Width . . . 755 mm (29.7 in)
Overall Height . . . 1,185 mm (46.7 in)
Wheelbase . . . . . . 1,385 mm (54.5 in)
Seat Height . . . . . 805 mm (31.7 in)
Frame
Rake . . . . . . . . . . . 23.9°
Trail. . . . . . . . . . . . 92.4 mm (3.64 in)