Troy-Bilt 11a-bobl.765 User manual

778-12364A© 2013 11A-B06
Starter
Rope Handle
Blade Control Handle
Wing Nuts
T-Bolts
A. Remove the wing nuts and carriage bolts
securing the upper handle to the lower
handle.
A
Pivot the upper handle
upward.
B. Remove T-bolts from
the handle brackets.
A. Pull upward on
the handle until
the holes in lower
handle line up
with the holes
in the handle
bracket.
A
B
A. Insert the T-bolts removed in Step 1B
through the handle brackets to secure
the handle in place.
A. Hold blade control handle against upper handle.
B. Slowly pull starter rope handle from engine and
slip starter rope into the rope guide.
C. Tighten rope guide wing knob.
D. Use cable tie to secure cables to lower handle.
A
B
C
D
B. Secure upper handle
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
A
B
B
14
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING . Need Help? Call 1-888-TO-HELP-U

Oil Fill /
Dipstick
Primer
Gas Fill
778-12364A© 2013 11A-B06
Push the primer three times.
Fill fuel tank with clean, fresh gasoline. Do not
fill above the base of fuel tank neck.
Pour the entire contents of the oil bottle (supplied)
into the oil fill. Check the oil level using the
dipstick. (Refer to the Operator’s Manual)
While standing behind the machine, pivot the Blade
Control Handle against the upper handle.
Grasp the starter rope handle and pull with quick, full-
arm stroke. If the engine does not start after five pulls,
repeat steps 8 and 9.
3
68
79
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING . Need Help? Call 1-888-TO-HELP-U