Truax Timber Traditional Chair User manual

Traditional/Michigan Chair Assembly Instructions
We recommend you use a screwdriver and socket to hand tighten so you do not drill through.
If you choose to use a power drill, DO NOT OVER TIGHTEN.
Here are the five pieces you will assemble:
1. Preassembled chair base
2. Preassembled chair back
3. Right arm/leg
4. Left arm/leg
5. Front support
Hardware (included):
(12) Washers
(12) Lag Screws
(22) 1 1/4" Screws
Required tools (not included):
Philips screwdriver
1/2" socket or wrench
Visit www.truaxtimberco.com/instructions to view these same instructions online

Step 1 - Back and Base
Stand base on its side.
Line up the two (2) dowels on the
chair back with the holes on the chair base.
Insert the dowels into the holes lining
up the back and base.
Step 2 - Back and Base
Insert one (1) washer/lag screw into each of the two
holes underneath the chair and tighten.
Now the back and base are secured to each other.
Step 3 - Back and Base
Insert six (6) screws into each of
the six (6) pilot holes.

Step 4 - Leg and Arm
With the chair still on its side, line up and
insert the dowels on the leg with the center
on the chair base.
Align the back of the arm with the holes on the back
support piece. Keeping your hand on the arm, insert
one (1) washer/lag screw and two (2) screws into the
pilot holes and tighten.
Step 5 - Leg and Arm
Insert four (4) washers/lag screws into the front leg
and tighten them. Insert four (4) screws into
pilot holes and tighten.

Step 6 - Leg and Arm
Repeat Steps 3, 4, and 5 for the
other side of the chair.
Step 7 - Front Support
Turn chair over. Fit the support board in to the
slot and insert two (2) screws on each side and tighten.
Step 8 - Completion
Make sure all lag screws and screws are tight.
Chair assembly is now complete.
Set the chair upright and relax!