TSI Instruments DUSTTRAK 854030 User manual

_______________
TSI and TSI logo are registered trademarks of TSI Incorporated.
INSTALLING THE POWER SUPPLY
INTO ENVIRONMENTAL ENCLOSURE
MODEL 854030
QUICK START GUIDE
This guide will help you quickly install the Power Supply
for Environmental Enclosure Model 854030.
Unpacking the Power Supply
(854034) for the Environmental
Enclosure (854030)
1. Unpack the Power Supply (854034) for
Environmental Enclosure (854030) and verify that all
the items listed in the following table are present.
2. Contact TSI immediately if items are missing or
broken.
Qty.
Item Description
Reference Picture
1
Power Supply
1
Mounting Bracket
User Replaceable Parts
Reference
Picture
Description
Manu-
facturer
Part
Number
Connector
2 Position
Spring Cage
SP 4/2
Phoenix
Contact
3042890
Power Supply
Ground
Phoenix
Contact
3042722
Power Supply
Connection
Phoenix
Contact
3042719
External AC Electrical Cord
The 854034 Power Supply will be shipped with a
country-specific External AC Electrical Cord configured
for plug receptacles in the country receiving the
instrument. Alternate External AC Electrical Cords can
be ordered referencing the part numbers below.
Part number
Description of Cord End Plug
1303900
US
1303901
Euro
1303902
Australia/ China
1303903
UK/HK
1303904
Switzerland

TSI Incorporated –Visit our website www.tsi.com for more information.
USA Tel: [phone]
UK Tel: [phone]
France Tel: [phone]
Germany Tel: [phone]
India Tel: [phone]
China Tel: [phone]
Singapore Tel: [phone]
P/N 6008574 Rev. B ©2016 TSI Incorporated Printed in U.S.A.
Installing the Power Supply
(854034)
WARNING
The 854030 Enclosure has been designed
to be used with TSI supplied Power
Supplies Only. DO NOT use any
substitutions.
C a u t i o n
Prior to installing/removing the 854034
Power Supply ensure all external power
going into the 854030 is turned off and
the external supply cable is disconnected
from the external connector on the
854030 Enclosure.
1. Remove the KEP-Nut from the standoff (qty: 2) and
install the DIN Rail Mount and DIN Rail.
2. Install Power Supply into Mounting Bracket.
3. Install power supply and mounting bracket onto DIN
Rail by hanging bracket by the top clip and pushing
the bottom of the bracket down into place.
4. Attached Power Cord.to Power Supply.
5. Plug Power Supply into Lower DIN Rail.
Power Supply Specifications
Output Voltage.....
24 VDC
Rated Current.......
5A
Rated Power.........
120 W (max)
WARNING
DO NOT hot-plug the Power Supply into
the DIN Rail. Always connect the 854034
Power Supply first and then turn on any
components located in the 854030
Enclosure.
WARNING
The 854034 Power Supply is not weather
proof and should NOT be subjected to
outside precipitation or other adverse
outside weather conditions.