Tundra Drone AUTOMOVING LIGHT User manual

SCAN FOR USER MANUAL
AUTOMOVING LIGHT
FOR DJI MAVIC 3
QUICK START GUIDE
Designed in Norway
Find the detailed User Manual: https://tundradrone.com/support
Manufactured by Tundra Drone AS | Bredbuktnesveien 2 | 9522 | Kautokeino | Norway
TUNDRA
DRONE

INSTALLATION
Mount the green tracking mark sticker aligned to the
circle on the aircraft's camera. Mount the red tracking
sticker on the aircraft's camera (see illustration).
Position the Automoving light unit below the
aircraft. Insert the aircraft from above into the
Automoving light's inner body.
Place the Automoving light Battery into the
Automoving light's battery slots' starting point. Press
in the «Battery Latches» on both sides of the battery
and slide the battery. Make sure the battery is mounted
securely and that the «Battery Latches» have clicked
into place on both sides.
When correctly mounted, there should be no «GAP»
between the battery and the battery connector on the
Automoving light unit. Hold the power button on the
battery down for around 3 seconds to turn on the
Automoving light. On startup the floodlight LED will
blink once, when the boot sequence is ready the lamp
will blink one more time.
Set the function of the customizable «C2 button» in the
DJI Controller to turn on/off the «Recenter/Tilt down
gimbal». The light is toggled when the camera goes
from horizontal to straight down and back to horizontal
within 2 seconds, this is done by clicking the C2 button
two times within 2 seconds.
Power up the aircraft and make sure that the DJI Fly
app connects to the aircraft. Tilt the «Drone Camera»
by pressing the «C2 button» horizontal to straight
down and back within 2 seconds with the DJI Remote
controller (the flood light will turn «ON/OFF» after
Autom ovi ng ligh t is mou n te d to the drone
successfully).
12 3
4
NO GAP
5
6
Horizontal Position Horizontal to straight down