Tunstall Roche CoaguChek XS System User manual

The CoaguChek® XS instrument is for healthcare professionals and their patients to enable
PoCT for INR (International Normalized Ratio) from a drop of capillary whole blood. It uses fresh
capillary or nonanticoagulated venous whole blood. It is simple, fast, easy to use and reliable.
Roche CoaguChek XS System
What is it?
How does it work?
Note: Always keep the CoaguChek, lancing device, test
strips and lancets in the carrycase.
Caution: You must wash your hands before using this device.
When prompted to measure your INR level by myMobile,
please follow the steps below:
STEP 1
Insert a test strip into the CoaguChek INRange device with
the arrows showing upwards (this turns the unit on).
STEP 2
Remove the rotating end of the lancing device and insert
the flat end of a new lancet.
STEP 3
Gently twist the protective cover off the end of the lancet
and replace the end of the lancing device (it will click when
replaced properly).

STEP 4
Prick your finger with the Roche Softclix XS lancing device
and place a drop of blood on the strip.
STEP 5
The CoaguChek will analyse the sample and upload the
result to myMobile. Tap ‘Continue’ on myMobile.
STEP 6
Remove the protective end of the lancing device and press
the yellow button to eject the lancet into a sharps bin.
Remove the test strip from the CoaguChek device and
dispose of it in your normal household rubbish.
STEP 7
To switch the unit off press
Our policy of continual development means that product specifications and appearance may change without notice. Tunstall does not accept
any responsibility for any errors and omissions contained within this document. © 2020 Tunstall Group Ltd. Tunstall is a registered trademark.
Tunstall Australasia Pty Ltd is a member of the Tunstall Group.
8271-UG-10
Tunstall Australasia Pty Ltd is a member of the Tunstall Group.
Tunstall Australasia t/a Tunstall Healthcare
ABN 44 056 121 863
t: 1800 603 377
e: [e-mail]
w: tunstallhealthcare.com.au
Tunstall New Zealand
Business No. 3502431
t: 0800 488 678
e: [e-mail]
w: tunstall.co.nz
Cleaning Instructions
• Clean the device at least weekly or if visibly soiled.
• To clean the exterior, use a soft cloth, slightly dampened (not wet) with a small amount of
liquid soap diluted in water. Ensure the meter is powered off and then wipe it clean. Do not
let liquid accumulate or enter any opening.
• Use only 70% isopropyl alcohol or 10% Sodium hypochlorite solution to clean/disinfect the
CoaguChek XS meter housing for a contact time of <1 minute.
• For drying, use a lint-free tissue to wipe away residual moisture and fluids and wait for at
least 10 minutes before performing a test.