Tuson RV TPMS-TRIGGER User manual

NO
1
2
3
2
1
1
TPMS Sensor Activation Tool User Manual ( RV TPMS - TRIGGER )
Product Introduction
Applied Product Model
This product is ONLY used on the 433MHz sensor for the Tuson TPMS Retrofit Kit.
FCC and CE Regulations
This tire pressure monitoring system has complied with Article 15 of the FCC and CE regulatory requirements
of the USA and EU, but it is still needed to pay attention to the following two items:
(1) Other harmful interferences may affect the system’s normal operation.
(2) Abnormal operation may cause the system to fail.
Product List
Part Name Q’ty
TPMS Sensor Activation Tool
1.5V AAA Battery
User Manual
Product Specification
Item
Operating Voltage
Operating Current
Operating Temperature
Operating Radio
Frequency
Modulation
Storage Temperature
Battery
Dimension
Weight
(Battery not included)
Specification
DC 3V
65mA
-18℃~55℃
-18℃~55℃
LF:125KHz,RF:433MHz
ASK/FSK
AAA 1.5V *2
150 x 55 x 32mm
98g ± 5g
Rx
Enter
Tx
Operation Steps
Product Appearance
indicator --- LED lights up, if the
trigger function operates normally
indicator --- LED lights up, if the
--- Trigger button
1. Insert two AAA batteries into the tool by opening the battery cover on the
back of the tool.
2.1
2.3 Press the “Enter” button. If the Tx indicator lights up after one second,
3.1 Successful receiving:
If the Rx indicator lights up and the tool buzzes twice in short tones,
3.2 Unsuccessful receiving:
Note:
If the Tx indicator does not light up and buzz after 5
seconds, or the trigger function works intermittently,
the batteries may be low and need to be replaced.
1. The aim is to quickly detect if the Tuson Retrofit TPMS Sensor (hereinafter referred to as: sensor)
is operating normally or not.
2. Use Tuson TPMS sensor activation tool (hereinafter referred to as: tool) to trigger the sensor, tire
deflation to get the signal, saving time for ID learning and checking the tire pressure value.
(shown in the receiver display Tuson TPMS Retrofit Kit).
tool receives the signal from the
sensor after trigger button is pressed
Select the sensor you would like to check for normal operation, tire
pressure or perform ID learning. (Note: If you are checking for tire
pressure or performing ID learning, you will need to go to the appropri-
ate receiver display screen on the Tuson TPMS Retrofit Kit to perform
these functions. Refer to the Tuson TPMS Retrofit Kit User Manual to
initiate the Tire Sensor ID Pairing to the Receiver in the receiver's
setting menu.)
then that indicates the trigger function is operating normally and the tool
has sent out a signal successfully.
that means that the tool has received the signal from the sensor
successfully. (Note: If you are checking the tire pressure on the
receiver, the corresponding TPMS sensor will populate a pressure
reading on the receiver display. If you are performing ID learning, the
sensor ID# will populate for selected tire location number on the
receiver display indicating that the sensor has been paired.)
If the tool buzzes in one long tone after 5 seconds,then that means
the tool did NOT receive the signal from the sensor.
Please repeat step 2, adjusting the angle and distance of the tool
relative to the sensor until the Rx indicator beeps twice.
2.2 Place the tool with the signal icon pointing toward the tire onto the
sidewall of the tire where the selected sensor is located.
TUSON

Limited Warranty
Customer Service
Tuson RV Brakes, LLC (Tuson) warrants the TPMS Sensor activation tool kit(s) to be free of defects in
material and workmanship for a period not to exceed TWO (2) years from the date of sale to the original
consumer, or to the first retail purchaser of a trailer on which the TPMS Sensor activation tool kit is installed.
Original receipt(s) or other acceptable proof of purchase should be retained by the customer for verification
of warranty date. THIS WARRANTY IS NOT TRANSFERABLE.
Tuson's obligations under this warranty shall be limited lo crediting the account of a direct buying distributor
or OEM trailer manufacturer, replacing or repairing the TPMS Sensor activation tool kit products which are
determined by Tuson to be defective in material or workmanship, within 60 days of receipt of such product
by Tuson. Tuson reserves the right to request the product be returned intact, freight prepaid, PRIOR to
processing any claim for warranty.
Warranty claim must be received by Tuson within 30 days of the discovery of the alleged defect, or within 30
days of the expiration of the warranty, whichever is earlier. Covered repairs or replacements will be made at
Tuson's expense. Shipment of replacement product or repaired product by Tuson will be via best available
ground shipment carrier. Shipments other than by best available ground shipment carrier, must be
requested in writing and must be paid for in advance by the customer. Returned product that is found not to
be defective, will be returned at sender's expense.
This Warranty shall not include any products which have been improperly installed, installed contrary to
installation instructions provided with the product, altered, tampered with or changed in any way, or utilized
in a manner not approved by Tuson. This Warranty shall not extend to any defects arising from abuse,
misuse, accident, improper wiring, or negligence of the installer or the consumer.
EXCEPT AS EXPRESSLY SET FORTH ABOVE, NO OTHER WARRANTY, EXPRESS OR IMPLIED, AT
LAW OR IN EQUITY, IS MADE BY TUSON CORPORATION IN RESPECT OF THE PRODUCT, INCLUD-
ING WITHOUT LIMITATION ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A
PARTICULAR PURPOSE OR ANY OTHER WARRANTY, AND ANY SUCH WARRANTIES ARE
EXPRESSLY DISCLAIMED.
IN NO EVENT SHALL TUSON BE LIABLE TO PURCHASER OR ANY THIRD PARTY FOR ANY LOST
PROFITS, CONSEQUENTIAL, EXEMPLARY, INDIRECT, PUNITIVE, INCIDENTAL, OR SPECIAL
DAMAGES OR COSTS (INCLUDING ATTORNEY FEES), OR LOSS OF GOOD WILL RESULTING FROM
ANY CLAIM (INCLUDING BUT NOT LIMITED TO ANY CAUSE OF ACTION SOUNDING IN CONTRACT,
TORT, NEGLIGENCE, STRICT LIABILITY OR PRODUCT LIABILITY) REGARDING THIS AGREEMENT,
EVEN IF THE COMPANY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the exclusion or limitation of implied warranties, incidental or consequential
damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific
rights. You may have other rights, which vary from state to state.
All product support is provided by the distributor that your product was purchased from. Please contact the
distributor who originally sold you your Tuson product.
Or contact us:
Toll Free: 800-968-8766 Email: [email protected]
Tuson RV Brakes, LLC, 475 Bunker Court, Vernon Hills, IL 60061
www.tusonrvbrakes.com