Assembly Instructions CBT24
6
The payload of the CBT24 cradle bar for flying is designed of not more than six T24(N) loudspe-
aker. The following additional components are required for this: BCT24 rigging adapter,
BBT24 bracket and BLT24 Boxlink connecting cables on both sides of the T24(N) loudspea-
ker. Do not exceed this payload.
When moving (assembling, dismantling, maintaining) the CBT24 cradle bar for flying with
T24(N) loudspeaker, ensure sufficient space to prevent collisions with other objects.
Do not squeeze or twist the electrical cables of the T24(N) loudspeaker during the installation
of the CBT24 cradle bar for flying! The respective national electrotechnical rules and regula-
tions are applicable.
Before mounting the CBT24 cradle bar for flying check that e.g. ceilings are capable to
carrying the payload of the components.
Make sure that no water pipes, electrical lines or any other lines are behind the intended place
of mounting.
Only use wall plugs and screws which are suitable for the intended mounting and structural
fabric. All screws must be set and tightened properly. Ensure that the fixing holes have the
correct depth and diameter. Always use all fixing holes.
Check the Double Stud connections each time you install the CBT24
cradle bar for flying.
They must be firmly engaged and secured with a safety locking splint. If this is no longer pos-
sible, the Double Stud connections with the safety locking splints must be replaced.
When working with heavy loads exceeding 20 kg (44 lbs.), use suitable aids (dollies, hoisting
slings, etc.). Multiple persons may be required depending on the situation.
