Assembly Instructions BCT24
6
The payload of the BCT24 rigging adapter is designed of not more than six T24(N) loudspe-
aker. The following additional components are required for this: CBT24 cradle bar for flying,
BBT24 bracket and BLT24 Boxlink connecting cables on both sides of the T24(N) loudspea-
ker. Do not exceed this payload.
When moving (assembling, dismantling, maintaining) the BCT24 rigging adapter with
T24(N) loudspeaker, ensure sufficient space to prevent collisions with other objects.
Do not squeeze or twist the electrical cables of the T24(N) loudspeaker during the installation
of the BCT24 rigging adapter! The respective national electrotechnical rules and regulations
are applicable.
Before mounting the BCT24 rigging adapter check that e.g. trusses or ceilings are capable to
carrying the payload of the components.
Make sure that no water pipes, electrical lines or any other lines are behind the intended place
of mounting.
Only use wall plugs and screws which are suitable for the intended mounting and structural
fabric. All screws must be set and tightened properly. Ensure that the fixing holes have the
correct depth and diameter. Always use all fixing holes.
When working with heavy loads exceeding 20 kg (44 lbs.), use suitable aids (dollies, hoisting
slings, etc.). Multiple persons may be required depending on the situation.
All screw connections should be checked when the BCT24 rigging adapter is installed. If
there are loose screws, tighten them. If this is no longer possible, the screws and nuts must
be replaced.
Whenever you make changes to the flown system, always use new hexagon screws (Item2)
and hexagon nuts (Item 3) as delivered with the product. These items are available from
TW AUDiO.
