Twin Eagles TEGB36-B User manual

P/N: 18542F (04/17)
TWIN EAGLES GRILL BASE
BASE ASSEMBLY & GRILL HEAD INSTALLATION
MODELS:
TEGB30-B
TEGB30SD-B
TEGB36-B
TEGB36SD-B
TEGB42SD-B
TEGB54SD-B
TEGB30SD-B SHOWN

1
ASSEMBLY INSTRUCTIONS
(A) Caster w/ Brake
(qty. 2)
(TEGB54SD-B: qty 3)
(B) Caster (qty 2)
(TEGB54SD-B: qty 3)
(D) Shelf Bracket (left)
(qty 2)
(E) Shelf bracket (right)
(qty 2)
(G) Hex-head Philips
screw (pre-installed w/
washers) (qty 2)
(I) 10-32 x ½” Phillips
screw (qty 2)
(C) ¼”-20 hex nut
(qty. 16) (TEGB54SD: qty 2)
(F) Flat head screws
(qty: 8)
(H) Flat-washer
(preinstalled w/ hex
screw)
(qty 2)
1. Install casters with brakes (A) at the front of the base
and casters without brakes (B) at the rear and secure
them with nuts (C).
2. Install shelf brackets (D) and € securing them with
screws (F) and side shelves.
3. Remove hex head screws (G) and flat-washer (H) using
a 5/16” wrench and place the grill head into the cart.
4. Install the hex-head screws (G) with flat-washer (H)
back into place by initially hand tightening them. Then
use the 5/16” wrench to tighten the screws completely.
5. Fasten the BBQ grill at the top-rear corners using the
Phillips screws (I), reference picture no. 2
(B)
(C)
(A)
(D)
(E)
(F) ( I )
( I )
(G)
(G) (H)
(H)

2
ADDITIONAL INSTRUCTIONS
TO SECURE POWER TRANSFORMER
All B-Series grill models come with a power
transformer which is concealed in a stainless
steel box with an attached power supply
cord. This transformer must be secured in a
dry location and away from excessive heat.
1. In a base cart application, 2 mounting
screws with nuts are provided at the
bottom-right-rear corner of the cart.
If not provided, drill 2 holes using the
transformer box as a template.
Secure the transformer box as shown.
2. Plug-in the transformer’s power cord
to the properly grounded GFCI 120V
outlet.
3. Connect the transformer harness to
the harness located at back of the
grill.
•FOR C-SERIES GRILLS THIS
DOES NOT APPLY.
SIDE SHELF
Side shelf UP (User position): Hold the side shelf from the end, flip it up and push the side shelf down at the
bracket area. Be sure that the side shelf has lock down before placing items
on the shelf.
Side shelf DOWN (Non-users position): Hold the side shelf from the sides around the bracket area, pull it up
and then flip it down.