TXper nVR-15W User manual

Quick Installation Guide
nVR-15W/15RW
www.telexper.com

1
Network Video Recorder
Network Video Recorder Network Video Recorder
Network Video Recorder VR
VRVR
VR-
--
-15
1515
15W
WW
W/15
/15/15
/15RW
RWRW
RW
Installation
InstallationInstallation
Installation
Connect the nVR to the CMS network; the CMS system will auto detect the nVR devices
without any additional configuration。󰆎
Record Function
Record FunctionRecord Function
Record Function
Please use CMS to manage the recording task
Product Overview
Product OverviewProduct Overview
Product Overview
nVR
nVRnVR
nVR-
--
-15
1515
15W
W W
W / 15
/ 15/ 15
/ 15RW
RWRW
RW

2
Network Video Recorder RAID 5 Setup
Network Video Recorder RAID 5 SetupNetwork Video Recorder RAID 5 Setup
Network Video Recorder RAID 5 Setup
1. Insert HDD to NVR and restart the system. A pop-up window (see picture below) will
appear. Click to stop the program.
2. On your system desktop, double-click HighPoint Web RAID Management
shortcut .
3. Internet Explorer will be initiated automatically. Please select “Continue to this website
(not recommended)”to continue to the main page of HighPoint Web RAID
Management.

3
4. Enter User Name: RAID, Password: hpt, and then click .
5. After log in successfully, you will see Logical Device Information page.
Ensure the quantity of HDD is correct. If not, please turn off the system to check
whether HDDs were inserted properly or were defective.
Under Physical Device Information section, you can distinguish the new/used
status of the HDDs from the HDD icon. HDD icon with letter L (Legacy) on it is for
used HDD. HDD icon without any letter is for new HDD.

4
6. After checking the HDD Status, go to Manage, then select Device.
7. Under Manage page, click to enter Initialize Physical Device page.
8. Click to select all un-initialized HDD, and then click to start.

5
9. Click OK on “All data on the disk you selected will be deleted. Do you want to
continue?”
10. System will message you for every completion of each HDD.

6
11. After completion of HDD initializing, there will be no letter on the HDD icons on the
Physical Device Information.
12. Go to Manage and select Array.

7
13. Click to enter Create Array Page.
14. Under Create Array page, select RAID 5 for Array Type, Foreground for Initialization
Method. Click to select all HDDs, and then click to begin.

8
15. A message will appear upon completion.
16. Initialization process will begin upon array creation.
17. Upon initialization process, the status will become Normal.

9
18. Please restart the system.
19. When you restart the system, the System Process window will appear. This time,
please do not click and wait 30 seconds for this window to disappear.
20. The system will ask for HDD formatting. Please click to begin HDD
formation process.
21. Upon HDD formation, the system will automatically restart again and start NVR
program.
Notice: If the network video recorder is nVR-15 or nVR-15 RAID series, please insert the
HDD rack from left bottom to the right top, in order to prevent no detection of HDD.