PAGE 1 OF 2 0214 IH-1103
πH -1103
plastic smoker’s
receptacle
1-800-295-5510
uline.com
NOTE: Your new Plastic Smoker's Receptacle
is fully assembled and ready to use. However,
we recommend adding weight to the base to
avoid tip-over in adverse weather conditions.
TO ADD ADDITIONAL WEIGHT:
1. Unscrew and remove black
knob on the unit. Then tilt the
neck to clear the opposite tab
from slot and remove the lid
from the base.
(See Figure 1 and 2)
2. Remove pail from base.
3. Fill the base with sand,
approximately 1/3 to
1/2 full. Another option
is to place some bricks
or rocks inside the base.
Do not fill with water.
4. Place pail back in
base on top of sand.
(See Figure 3)
5. Once the weight has been added, place the lid
on the base. With the neck tilted, align the tab on
the lid with the slot on the base. Tilt the neck upright
inserting the tab into the slot. Align the hole in front
of the lid with the nut insert in the base and screw in
the knob to secure lid and base together.
CAUTION: Plastic Smoker's Receptacle has
been specially designed to limit the flow of
oxygen, thereby eliminating the chance of fire.
To function properly, this unit must be securely
closed at all times.
INSTRUCTIONS
Figure 1
Figure 3
Figure 2
