Light emitting diodes (LED’s)
LED’s from left to right:
Link LED Ethernet cable is OK when lit
Act. LED Frequent flashing means data exchange
LED –bi-color LED:
Red flashes 2 times per second –no connection to the ACS server
Green flashes once per second –connection to the ACS server is OK
Connection and mounting
U-Prox HE shipped in the plastic enclosure without the power supply. Dimensions marked on the Fig. 3.
Connection
1. Perform initial network setup of
device (that specifies settings of
network parameters) with utility
"Configurator" via USB port before
installation, if it is impossible to
adjust them automatically
2. Prepare the place for installation
mark and drill mounting holes (see
Mount recommendations)
3. Perform Ethernet wiring
4. Perform power wiring if it is necessary
5. Install and fix the enclosure cover with screws
6. Attach self-adhesive washers over the screws
7. Load the Device in the U-Prox IP software (according to the software manual)
8. Download the Device
9. The device is ready for operation
Mounting recommendations
Mount the Device in the place, convenient for
service.
To mount the Device on the wall, perform the
following (Figure 4.):
Mark the holes using the tem plate
provided;
Fix the enclosure;
Connect wires