UCLEAR Pro Microphones Placement
Mounting the UCLEAR Pulse Pro
Dual MEMS microphones in Full
Face, Modular, and ¾ Helmets:
Remove the helmet headliner from
the front/brim.
Using the included small hook &
loop mic mounting rounds, or tape,
mount the Pro-Microphones under
the liner in the brim of the helmet.
Typically, this brim material is
perforated and unpadded. Avoid
placing the microphones inside air
vent channels.
Tuck excess wire under the
headliner and refit your headliner
over the microphones. When
headliner and padding is replaced,
none of the microphones or wires
should be visible.
Place wide, near outside edges
of eyebrows near temple.
Tuck excess wire under liner.
Microphone Mounts
UCLEAR Pulse
Pro Dual
MEMS
Microphones
and Speakers
