Ude PX-99 User manual

DESCRIPTION
Mixer preamplifier with 8 convertible microwave auxiliary inputs (INPUT-
1 .... INPUT-8) and 2 outputs level 0 dBu (OUTA, OUT B).
The PX-99 is used to assign each input to output A, output B or both
(option C), acting as a matrix of 8 inputs / 2 outputs, with total flexibility.
Each input can be configured as balanced microphone or as an auxiliary
unbalanced.
The microphone inputs have phantom supply and configurable
password filter.
Each entry has: volume control, independent bass and treble.
Assignable priority level to level 1 (minimum level of priority) to 8
(maximum) for the automatic control signal.
VOX function. Each entry has a level sensor with an adjustable
threshold (0 to 50), so when the signal exceeds the trigger level, the
channel opens. This can also be used as an automatic switch signal, and
as a noise gate.
At each entrance, together with the VOX function (and with priority level
greater than 1) we can assign the remote function. When the VOX
function of this input is activated besides open the audio channel, will be
a remote contact closure to ground (open collector) in the remote output
terminals,Aor B as appropriate entry.
In each outputAand B offers master volume independent.
The outputs can adjust the level to 0 dB and -6 dB.
The device, in addition, has a limitation that prevents the saturation
level in the output.
Possibility of inserting a coupler module WX-19 in each output.
It also has two sets of keys (treble) / (bass) called F1 and F2, which
can be assigned to any volume control, whether a particular input or
master.
To configure the PX-99 is necessary to go into the USER MODE.
During configuration (volume tones, VOX, etc...), the device
operates in real time, offering the result of what is done.
Once the installation and the configuration are done, leave the
technical mode. The device is in USER MODE.
When you use the display it will shows two bars as vumeter.
In USER MODE can influence the volume settings of the bass and
treble for each entry.
In addition, at any time, can act directly on the F1 and F2, which will
act on what they have assigned.
The new settings are stored in non-volatile memory. It means that
when you remove and replenish the system, they remain in it.
8 inputs for configurable micro / aux (XLR).
2 Outputs 0 dBu (XLR).
Volume and tone control independent for each input.
VOX detector with adjustable threshold for each input.
Priority configuration input.
Assigning inputs for each output. Configurable.
2 Function keys.
Alphanumeric display 2x16 characters.
MAIN FEATURES
USB
TLA GND TLB
MIC/AUX 1 MIC/AUX 2 MIC/AUX 3 MIC/AUX 4 MIC/AUX 5 MIC/AUX 6 MIC/AUX 7 MIC/AUX 8 OUT A OUT B
REMOTE CONTROL PROGRAM SF-99
www.udeaudio.com
The preamplifier PX-99 has a remote control program named SF-99, to run in PC, and it is possible to download it from website
. Using this software and connection cable USB type B, you can configure all characteristics of the amplifier: volume, bass
and treble, auxiliary input, sensitivity and recuperation time of VOX control, inputs a outputs routing, priority, phantom power, keyword filter, remote
control and attenuation of -6dB.
Also allows the record of one security copy of configurations for PX-99 installation, so is possible programming the equipment many times if is
necessary.
61
610.424A
rev.1
EQUIPOS Y SISTEMAS MEGAFONÍA / INTERCOM PUBLIC ADDRESS SYSTEMS
[email protected] BARCELONA - SPAIN
Tel.: [phone]
PX-99
DIGITAL PREAMPLIFIER / MATRIX
8 INPUTS / 2 OUTPUTS

14
7
6
10
25
8
9
3
ON / OFF switch
Alphanumeric display. Vumeter.
Function keys F1.
Navigation keys.
Function keys F2.
19
USB communication port
AC Fuse T0,5A.
Electrical output 230 VAC.
11
12
13
Micro / Aux Input 1 (XLR)
Micro / Aux Input 2 (XLR)
Micro / Aux Input 3 (XLR)
Micro / Aux Input 4 (XLR)
Micro / Aux Input 5 (XLR)
Micro / Aux Input 6 (XLR)
Micro / Aux Input 7 (XLR)
Micro / Aux Input 8 (XLR)
14
15
16
17
18
Remote outputs A-B
0 dBm signal output A (XLR)
0 dBm signal output B (XLR)
- Distortion:
- Phantom supply:
- Word filter for microphone.
- Dimensions:
- Maximal consumption:
0 dBu / -6dBu.
- Outputs sensitivity:
- Weight:
- Frequency range:
- Power supply:
- Input MICRO sensitivity:
- Input AUX sensitivity:
1 mV / 600 (symmetric)
100 mV / 50 k (symmetric)
- Ton controls:
Less than 0,1%.
12 VDC.
700 Hz.
427 x 43 x 314 mm. (1 U).
10 VA.
2,95 Kgs.
50 Hz. a 18 Khz.
230 VAC (50/60 Hz).
Bass: 100 Hz. 10 dB.
Treble: 10 KHz. 10 dB.
TECHNICAL FEATURES
Inputs 1-2-3-4-5-6
Inputs 7-8
Todas las entradas:
Outputs:
Microphone
Phantom supply
Word filter off
Without remote control
Auxiliary
Volume adjustment: 5
Bass and High: 0
Vox: +4
Priority: 1 (without priority)
Output assignation: A
Volume control: 5
F1 : Vol. Control MASTER A
F2: Vol. Control MASTER B
Output level 0 dBu.
FACTORY SETUP
FRONT CONTROLS
REAR CONNECTIONS
OUT
21
3
IN
AUX
IN
MICRO 2211
33
USB
TLA GND TLB
12354
6 7 8 9 10 11 12 13 14 15 16 17 18 19
MIC/AUX 1 MIC/AUX 2 MIC/AUX 3 MIC/AUX 4 MIC/AUX 5 MIC/AUX 6 MIC/AUX 7 MIC/AUX 8 OUT A OUT B
PX-99
62
610.424A
rev.1

TON
CONTROL
TON
CONTROL
TON
CONTROL
TON
CONTROL
BLOCK DIAGRAM
TO INSERT
THE COUPLER
FOR
REMOVE THE
BRIDGE
WX-19
OUTPUT A,
D-A
TO INSERT
COUPLER
IN
REMOVE THE
BRIDGE
WX-19
OUTPUT B
D-B
D-A
D-B
WX-19 WX-19
1- Remove the cover of the unit.
3- Assemble the in its position using the screws provided.WX-19
4- Connect the 6 cables hose as shown.
5- Remove the bridge ( ) or ( ). Don't require further adjustments.D-A D-B
7- Replace the cover.
NOTE: WX-19
D-A D-B
When you remove the module device, it is necessary to restore
the bridge ( ) or ( ) in place.
ASSEMBLY MODULE WX-19
PX-99
VOL
VOL
VOL
VOL
VOL.
MASTER A
VOL.
MASTER B
GND
TLA
GND
TLB
WX-19
(A)
WX-19
(B)
A
A
A
A
B
B
B
B
C (A+B)
C (A+B)
C (A+B)
C (A+B)
MIC/AUX 1
MIC/AUX 2
MIC/AUX 3
MIC/AUX 8
MATRIZ
8x2
OUT A
OUT B
VOX
VOX
VOX
VOX
VUMETER
VUMETER
PX-99
63
610.424A
rev.1

HOME SCREEN
__ __ __ __
__ __ __ __ B
A
HOME SCREEN
__ __ __ __
__ __ __ __ B
A
TO GO TO TECHNICAL MENU,
KEEP PRESSING
FOR 5 SECONDS
BOTH BUTTONS
TO LEAVE TECHNICAL MENU,
KEEP PRESSING FOR 5 SECONDS
BOTH BUTTONS.
OUTPUTS
INPUTS
CONFIG
IN
CONFIG
OUT
CONFIG
EXTER
PX-99
PX-99
PX-99
PX-99
CONFIGURATION
CONFIGURATION
EXTERNAL
CONFIGURATION
* * * *
ENTER A 4 FIGURES PASSWORD (1 to 4)
BY NAVIGATION AND VALIDATE
1
3
4
2
1
2
3
4
1
3
4
2
1
2
3
4
PASSWORD
ACCESS TO TECHNICAL MODE
OK
OK
PX-99
64
610.424A
rev.1

INPUTS SETTINGS
VOL / BASS / TREBLE
VOL
VOL
VOL
VOL
00 a 10
00 a 10
00 a 10
00 a 10
00 a +10 OUT-A ON/OFF
00 a +10 IN-3 ON/OFF
+00 a +50
+00 a +50
+00 a +50
BAS
BAS
BAS
BAS
IN-1
IN-2
IN-7
IN-8
IN-1
IN-2
IN-7
IN-8
IN-1
IN-2
IN-7
IN-8
-10 a +10
-10 a +10
-10 a +10
-10 a +10
-10 a +10
-10 a +10
1 2 3 4 5 6
1 2 3 4 5 6 7 8
7 8
1 1 1 1 1 1 1 1
1 2 3 4 5 6 7 8
AAACABBB
OUT-A, OUT-B, IN-1....IN-8
MITIGATE OUTPUTS A / B in -6DB
A= OUT-A
B= OUT-B
C= OUT-A + OUT-B
from to18
1= Lower priority
8= Higher priority
INPUTS SELECTION
MICRO or AUXILIAR
ENTER PASSWORD OF 4 FIGURES (1 to 4)
TRE
TRE
TRE
TRE
MIC
MIC
AUX
AUX
MIC
MIC
MIC
MIC
MIC
MIC
IN-AUX
IN-MICRO
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
FILT
FILT
FILT
FILT
PHAN
PHAN
PHAN
PHAN
PHANTOM SUPPLY SELECTION
FILTER SELECTION
VOX SETTINGS / = OPEN CHANNEL
REMOTE INPUT SELECTION
TL
TL
TL
TL
VOX
*
VOX
VOX
VOX
ASSIGN EXIT
INPUT A - B - C
ASSIGN PRIORITY
IN EACH ENTRY
OUT
IN IN
PRIOR
OUTPUT VOL ADJUST
MASTER A and MASTER B
ASSIGN FUNCTIONS TO F1 AND F2
AF1 A
BF2 B
VOL-OUT ASIG OUT-6dB
MASTER VOL
OUTPUTS
USE IN TECHNICAL MODE
CONFIGURATION
EXTERNAL
CONFIGURATION
CONFIGURATION
INPUTS
ENTER TO MODIFY
CURSOR APPEARS
VALIDEATE
SCREEN
HOME SCREEN
__ __ __ __
__ __ __ __
B
A
CONFIG
IN
PX-99
CONFIG
OUT
PX-99
CONFIG
EXTER
PX-99
OK
0,5 seg.
VOX RECOVERY TIME ADJUSTMENT
Recovery
time
VOX
TO LEAVE TECHNICAL MENU, KEEP PRESSING
FOR 5 SECONDS BOTH BUTTONS
FOR 5 SECONDS BOTH BUTTONS
TO GO TO TECHNICAL MENU, KEEP PRESSING
* * * *
2121
PASSWORD
PASSWORD
POR DEFECTO
PX-99
PX-99
65
610.424A
rev.1

INPUTS VOL / BASS / TREBLE
HIGH ADJUST
THE INPUTS MICRO / AUX SELECTION
IS JUST ADJUSTABLE IN THE TECHNICAL MENU
VOL
00 a 10
BAS A
A
A
A
IN-1 VOL-OUT
VOL-OUT
VOL-OUT
VOL-OUT
-10 a +10 00 a +10
00 a +10
00 a +10
00 a +10
-10 a +10 00 a +10
00 a +10
00 a +10
00 a +10
1 2 3 4 5 6
7 8
TRE B
B
B
B
MIC MASTER
MASTER
MASTER
MASTER
IN-AUX
IN-MICRO
MODIFY / VALIDATE PARAMETERS
VOL
VOL
VOL
00 a 10
00 a 10
00 a 10
BAS
BAS
BAS
IN-2
IN-7
IN-8
-10 a +10
-10 a +10
-10 a +10
-10 a +10
-10 a +10
-10 a +10
TRE
TRE
TRE
MIC
AUX
AUX
OUTPUTS MASTER A and
MASTER B ADJUST
IF NO BUTTONS IS PRESSED IN 20 SECONDS,
IT WILL GO BACK TO HOME SCREEN
HOME SCREEN
__ __ __ __
__ __ __ __ B
A
USER TO ACCESS THE MENU
CLICK TO MODIFY VALIDATE PARAMETERS
AND GO TO THE NEXT SCREEN
THE FIRST CONFIGURABLE
PARAMETER FLASH (level 1)
CLICKING
WE TURN TO THE NEXT
CONFIGURABLE PARAMETER (level 2)
CLICKING
WE TURN TO THE NEXT
CONFIGURABLE PARAMETER (level 3)
WITH THE BUTTON
WITH THE BUTTON
WITH THE BUTTON
WITH THE BUTTON
WITH THE BUTTON
WITH THE BUTTON
WE RAISING THE LEVEL
WE LOWER THE LEVEL
WE RAISING THE LEVEL
WE LOWER THE LEVEL
WE RAISING THE LEVEL
WE LOWER THE LEVEL
Level 1 Level 2 Level 3
CLICK
TO VALIDATE ALL PARAMETERS
INDICATED ON THE DISPLAY
VOL
00 a 10
BASIN-1
-10 a +10 -10 a +10
TRE
MIC
USE IN USER MODE
OK
PRESS THE OK BUTTON
OK
OK
PUSH TO RETURN
TO HOME SCREEN
OK
PX-99
66
610.424A
rev.1