Ultimax 8040 User manual

ULTIMAX 8040 DUAL BAND BAZOOKA
Thank you for the purchase of the ULTIMAX8040 dual
band double bazooka covering 80&40 Meters which is
accomplish by the use of no loss Hy-Q coils which
allow for dual band operation by adding a
broadbandwidth with low SWR in both bands, handling
legal limit with ease.
Installation:
1- lift the Apex (center) to at least 30-35' feet
2- lift the ends insulators to at least between
15-18' feet off the ground, acchive an invert "V".
3- Please avoid any other type of configuration
4- Use common sense, safety first keep away from
electrical wires.
5- Used ONLY RG-213, RG-8/U or RG-8X (don't used
coax with aluminum foil in the shield.)
Tuning:

80M: By simply folding in the ends making shorter
will raise the resonance in 75/80M, after achieving the
proper resonant point use the included zip tie and
push against the insulator and make tight, for the
remaining loose tail use electrical tape and keep it
parallel to it.
Note: fold 6-8" inches at the time evently in both sides.
40M: By opening & closing the Apex Angle you can
achieve the proper impedance at the center of the
band (7.150/7.175) and low SWR thru out most the
band.
Example A:

Example B:
Please follow the instructions correctly
no chokes , baluns are needed.
Thank you again for your purchase for customer
support please go to: www.ultimax-antennas.com