UNITED UND1094W User manual

USER MANUAL
REFRIGERATOR
UND1094W
Please read the following instruction carefully before using your refrigerator.
-Do not put hot food inside the refrigerator.
-Wrap all food items with a plastic protection film to avoid dehydration and lose food flavour.
-If you do not use the refrigerator for a long period of time, disconnect power, clean the inside parts, put the
refrigerator in a dry area and leave the door slightly open.

1
PARTS & FEATURES
Please read the following instruction carefully before using your refrigerator.
-Do not put hot food inside the refrigerator.
-Wrap all food items with a plastic protection film to avoid dehydration and lose food flavor.
-If you do not use the refrigerator for a long period of time, disconnect power, clean the inside parts, put the
refrigerator in a dry area and leave the door slightly open.
Ⅰ. GENERAL
The refrigerator is extensively used in places such as hotels, offices, houses and student dormitories. It is
mostly suitable for refrigerating and conserving foods such as fruits and beverages. It enjoys the advantages
of small size, light weight, high efficiency and low energy consumption.
Ⅱ.UNPACKING,REPACKING AND MOVING
1.Unpacking
Just cut off the packing band, then pull the carton up.
2. Repacking
Please remember to put the original foamed pads in place.
3. Moving
Be sure refrigerator stays in upright position during moving it.
Do not tilt it for more than 45°from upright. Never upset it.
Do not apply force on any external part such as pipe, condenser, door and its handle for moving, refrigerator

2
must be well packed and secured in long distance transportation to avoid damage from impacting and or great
rocking.
Ⅲ. OPERATION
1. Before the refrigerator is plugged in, check the following:
-There must not be any damage on all electrical wire
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the refrigerator can be plugged in.
2. When operating for the first time
When operating is in normal condition and the refrigerator without any load until it auto stops at the desired
temperature, Usually it takes 2 or 3 hours. Then set the thermostat to the required setting and place foods in.
3. Temperature control
Refrigerator’s temperature can be adjusted by
turning the knob of the thermostat. The closer to “7”
position the knob is set, the lower the temperature
becomes. A medium setting is the most suitable for
general operation. The position “7” is cool than the
position “3”.
Refrigerator’s temperature will vary depending on
the quantity of foods stored and the frequency of the
door opening, In order to maintain good cooling
efficiency and save energy, We recommend you not
to store too much foods and not to open the door too
frequently.
CAUTION: When the thermostat has been turned clockwise to “7”position, do not attempt to turn it more
over. Otherwise it will be damaged.
Ⅴ.THE USE OF SHELVES ,CRISPER DRAWERS AND FREEZER COMPARTMENT：
The refrigerator compartment is for storing the food need no frozen. And different compartment has
difference temperature; the temperature on the top of crisper drawer is the lowest. So difference
compartments suit for different food.
The shelves and door racks can be adjusted. You can adjust them base on the size or the quantity of food
which you need to be stored. Small food such as eggs ,bottles,canned food etc can be placed on the door
racks.Please lift the racks little when taking out the food. Large food can be placed on the shelves. Food
should not be place too much or too closed in order to allow air to circulate around each item.
Vegetables and fruits should be placed in the crisper drawer since the best storage temperature of them is
5℃. Vegetables and fruits should be packed before storage, in order to reduce the vapor of food cause
frost and energy consuming.
The freezer compartment is fore storing the food need frozen.
Freezer compartment. Frozen food should be packing before storage. It is advisable to cut large food into
once edible size and packed separately then place in the freezer drawers. It can reduce exhalation of food
and open door cause frost and energy consuming as well as avoid the food going bad because of thaw
and refrozen.
High efficient antibiosis

1
Handles, shelves in refrigerator chamber,crisper drawer, door gaskets, door racks, etc have been handled with
antibiosis.
Ⅵ.ENERGY SAVING ADVICE
Do not install the appliance close to sources of heat, such as a cooker, dishwasher or radiator.
Locate the appliance in a cool well ventilated room and make sure that air opening of the cabinet is not
obstructed.
Avoid unnecessary frosting in the cabinet by packing all foodstuffs in to airtight packages before placing
them in the freezer.
Food which is to be frozen (when cool) should be placed in the fridge before being transferred to the
freezer.
Thaw frozen food in the fridge, this will ensure safer defrosting of food and reduce the work of the
refrigeration unit.
Try to avoid keeping the food open for long periods, or opening the door too frequently as warm air
will enter the cabinet, and cause the compressor to switch on unnecessarily offer.
Ensure there are no obstructions preventing the door from closing properly.
It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or
vacuum cleaner.
Hot foods should be cooled down to room temperature before storage; otherwise, it would affect their
preservation and increase energy consumption.
Ⅶ.DEFROSTING
CAUTION: Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice from the
evaporator as this will damage the evaporator. A punctured evaporator will cause serious problems.
Ⅴ: CLEANING AND MAINTENANCE
1. To clean the refrigerator, disconnect power supply and remove foods, shelves, trays etc. Use a solution
mixed with 2 spoons of baking soda per litre of warm water to clean the interior. Then wipe it clean with
fresh water.
Never use acids, chemical thinner, gasoline, benzene or the like for cleaning any part of the refrigerator.
Never use oiling water and benzene to clean plastic parts because they may deform or damage the plastic
parts.
2. Too much foods or a too large container in the refrigerator will affect cold air circulation, so some free
space must be left. It is recommended that about 70% storage volume is loaded.
Do not store volatile and or explosive materials such as ethers, gasoline, liquefied petroleum gas, adhesives
etc. in the refrigerator. Otherwise there will be a danger of explosion caused by electric sparks.
Ⅷ. SAFETY INSTRUCTIONS
1. Before plugging your refrigerator in check that the electric supply in your house must comply with the
rating (voltage, frequency) of the refrigerator, the rating plate is usually on the back of the refrigerator.
The refrigerator should always be plugged in its own individual electrical outlet to prevent overload,
which could cause a possible fire hazard from overheating wires. Do not splash water on the refrigerator
as this will cause electrical leakage or failure. If the power cord becomes damaged, ask on electrician to

2
replace it immediately. The refrigerator must be properly earthed.
2. Our corporation is not responsible for any accident caused by improper earthing or improper operation.
3. Any repairs and work on the appliance should only be carried out by the customer service department, as
unauthorized work could prove highly dangerous for the user.
4. Do not store explosives or sprays using combustible propellants such as butane, propane, pentane etc.
5. Do not allow naked flames or ignition sources to enter the appliance.
6. Do not use steam cleaners for defrosting and cleaning.
7. Do not use mechanical devices or the other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
8. Do not damage the refrigerant circuit.
9. Do not use electrical appliance inside the food storage compartments of appliance, unless they are of type
recommended by the manufacturer.
10. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
11. The appliance must be positioned so that the plug is accessible.
12. If the supply cord is damaged,it must be replaced by a special cord ar assembly available from the
manufacturer or its service agent.
WARNING: Keep ventilation openings,in the appliance enclosure or in the built-in strcture,clear of
obstruction.
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process,other
than those recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food storage compartments of the
appliance,unless they are of the type recommended by the manufacturer.
Ⅸ. SERVICE
If the refrigerator is not functioning properly, check that:
1. When the refrigerator does not operate:
-the power plug is firmly in the wall outlet.
-the mains power switch is off.
2. When the refrigerator does not cool enough:
-the thermostat is at the correct setting, there are too frequent and too long door openings.
3.When the foods are frozen:
-the thermostat is at the correct setting.
4. When the refrigerator operates too noisily:
-the refrigerator is not touching furniture that can transmit or amplify a noise or a vibration.
-the refrigerator properly leveled.
-the containers or solid packages stored inside are not touching each other.
-the mains supply is stable.
If you refrigerator is still not functioning properly after making the above checks, please contact the sale
dealer immediately.
Note: During the period of high humidity, moisture may form on the outside of the refrigerator, it is not
unusual. You may just wipe it up yourself.
Ⅹ. OLD APPLIANCES
The cabinet of appliance is formed by cyclopentane or R141b. old appliance contain harmful materials and

3
should be disposed of with bulk refuse.
1.Remove the spring-action or bolt catch from the appliance or render it unusable so that children cannot
become trapped inside and suffocate.
2.Ensure that the refrigerant circuit is not damaged before the appliance that is no longer needed is taken
away for disposal. In this way the refrigerant will not escape into the environment.
Information concerning the refrigerant and insulating materials used can be found on the type plate and
disposal instructions on the appliance.
Information on collection dates or collection points can be obtained from the waste disposal authorities or
your local council.
Ⅺ.REVERSING THE DOOR
This refrigerator can be opened either from the left or right side. The default way of opening the door is from
the right side.
If you want to open the door from the left side, please follow the instructions below.
Hinge on the right side
Hinge on the left side

1. Remove the upper hinge cover(1), remove the Flange screw M5X16 (2) and the upper hinge(3), keep the
hinge for later use.
2. Remove the door(12) from the upper hinge(3), and keep the padded surface upwards to prevent the
scratching.
3. Remove the Flange screw M5X16 (6) that hold the lower door hinge(5), then remove the pin(10) from the
lower door hinge, keep the hinge for later used.
4. Insert the pin(10) previously moved from the right side and transfer it into the other hole at the left lower
side of the door.
5. Insert the lower door hinge(5) in the left lower side, fix the lower hinge on the cabinet by tightening the
Flange screw M5X16. (Showing the assembly instruction of the low hinge with the door opening at the right
side & left side as below)
Hinge on the left side Hinge on the right side
6. Remove the Plastic cover (14), and transfer it to the same location on the opposite side.
7. Remove the pin cap(13) from the left side of the upper frame of the door, and then transfer it to the same
location on the opposite side.
8. Put the door on the lower door hinge(5), keep the door level, then fix door on the cabinet by the upper
hinge(3), then fasten the screws.
9. Put the upper hinge cover(1) on the hinge(3).

1
Notice about recycling
Your product is designed and manufactured with high quality materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste collection/recycling centre. In the European Union there are separate collection
systems for used electrical and electronic products. Please help us to conserve the environment we live in!
Declaration of Conformity
This product complies with the requirements of the directives
EMC-Directive: 2004/108/EC
Low Voltage Directive: 2006/95/EC
CE Marking Directive: 96/57/EC
ROHS Directive: 2011/65/95/EC
EXCLUSIVE IMPORTER IN GREECE:
Amiridis –Savidis S.A.
33, Vas. Olgas Street –P.O. 54641 –Thessaloniki, Greece.
Tel: [phone], Fax: [phone]
45 Posidonos St. –O.P. 18344 –Moschato, Athens, Greece
Tel: [phone], Fax: [phone]
www.amiridis-savvidis.gr