UNITED VC-1156 User manual
Instructions Manual
2 in 1 vacuum cleaner
Model : VC-1156
Read and save these instructions for future reference
BEFORE USING THE APPLIANCE, CAREFULLY READ THESE INSTRUCTIONS:
WARNING: To reduce the risk of fire, electrical shock, or injury:
1. Do not leave the appliance unattended when plugged in. Unplug from the outlet when not
in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention is necessary when the appliance is
used near children.
4. Use only as described in this manual. Use only manufacturer’s recommended
attachments.
5. Do not use the appliance with a damaged cord or plug. Do not operate the appliance if it
has been dropped, damaged, left outdoors, or dropped in water. Return it to an
authorized service center.
6. Do not pull or carry the appliance from the cord, do not use the cord as a handle, do not
close a door on the cord, neither pull the cord around sharp edges or corners.
7. Do not unplug by pulling the cord. To unplug, grasp the plug, not the cord.
8. Do not handle the plug or the appliance with wet hands.
9. Do not put any object into the openings. Do not use with any opening blocked; keep free
of dust, lint, hair and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers, and all parts of the body away from the openings and
moving parts.
11. Turn off the appliance before unplugging.
12. Use extra care when cleaning on stairs.
13. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas
where they may be present.
14. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot
ashes.
15. Do not use without the filters in place.
16. Look on your vacuum and follow all label and marking instructions.
17. Keep end of hose, wands and other openings away from your face and body.
18. Always unplug this appliance before connecting or disconnecting the stick or floor brush.
19. Store the vacuum indoors. Put the vacuum away after use to prevent tripping accidents.
20. Using improper voltage may result in damage to the motor and possible injury to the user.
Correct voltage is listed on the rating label.
21. Use only on dry, indoor surfaces.
22. Do not use for any purpose other than the one described in this user’s guide.
23. If the cleaner is damaged, it must be repaired by the manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard.
24. Do not run the appliance over the cord. Keep the cord away from heated surfaces.
25. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
26. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
27. Children should be supervised to ensure that they do not play with the appliance.
1. If the suction nozzle or floor nozzle are blocked, turn off the unit, unplug the power cord
from the outlet, and only after making sure that the two previous operations have been
successfully carried out, remove the obstruction from the device.
2. Before operating the unit, be sure to remove from the surrounding every sharp or large
object that can clog or damage the device.
3. Avoid using the unit without the filter.
1. Stick and handle
2. Switch
3. Release button
4. HEPA filter
5. Dust bin
6. Release button for dust bin
7. Hooks for wire
8. Floor Brush
ASSEMBLY
(before assembling, make sure that the device is powered off and the cord is unplugged)
1. Insert and connect the floor brush onto the
lower part of the main body (as show in the
figure.
2. Press the clip of the main unit and insert the
handle into the opening.
Ensure that the handle is placed securely.
OPERATING:
1. Make sure that the floor brush or cleaner nozzle are properly assembled, according to the
intended use.
2. Roll out the cable and connect the plug to an appropriate power supply socket.
3. Press the start button and slide it to “I”. The unit will start to operate.
CLEAN:
1. After each use, place the switch to “0”and disconnect the plug from the mains.
2. Always allow the appliance to cool down before storing.
3. Remove the floor brush or vacuum cleaner nozzle.
4. To empty the dust box press the release button - the bottom compartment will open and
you can release the content. CAUTION: Make sure to do this when you are positioned over a
waste container.
Note: Empty the compartment when you see that it is full.
CLEANING THE FILTER:
Before cleaning, make sure the device is powered off and the cord is unplugged. Always
operate the cleaner with the filter installed.
The filter must be washed at least 2 times a year or more often if dirty.
1. Allow the appliance to cool down before cleaning.
2. Remove the filter and clean it under running tap water.
3. Tap the filter to remove thoroughly any water remaining in the filter and let it dry
completely for 24 hours before refitting into the device.
IMPORTANT: DO NOT CLEAN YOUR FILTER IN THE WASHING MACHINE AND DO NOT
USE THE HAIR DRYER FOR DRYING IT.
IMPORTANT: THE FILTER MUST BE CHECKED REGULARLY FOR SIGNS OF DAMAGE,
AND MUST BE REPLACED IMMEDIATELY IF DAMAGED.
TROUBLESHOOTING :
Problem
Possible cause
Proposed solution
Weak suction
Dust in the filter
Wash the filter
Dust bin full
Empty the dust bin
Obstacles in the
openings of the device
Remove all obstacles
Appliance is not
working
The plug is not
connected to the main
wall socket
Connect the plug of the appliance to
the main
wall socket
Overheat of the
body of the device
Slight temperature rising
on the accessible
surfaces of the device is
normal during use. In
case of higher
temperature rise, check that
the device suction nozzles
and openings of
the device are not
blocked
Check all opening of the device and
remove
obstacles that block and prevent air
circulation.
NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and
components which can be recycled and reused. This symbol means that
electrical and electronic equipment, at their end-of-life, should be disposed of
separately from your household waste. Please dispose of this equipment at
your local community waste collection/ recycling centre. In the European
Union there are separate collection systems for used electrical and electronic
products. Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the requirements of
below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: +302310944944 | F: +302310944940
www.amiridis-savvidis.gr
Table of contents
Other UNITED Vacuum Cleaner manuals
