Universal Audio Golden Reverberator User manual

User Guide
v210203

1/MONO 9VDC
USB
2/STEREO 2/STEREO
PAIR
IN
1/MONO
DECAY PREDELAY MIX
BASS TREBLE MOD
SPRING 65
PLATE 140
HALL 224
A
B
C
ON PRESET
STORE
Free Chamber & Plate 224 reverb effect, full
documentation, and help: uaudio.com/guitar/start
Power Supply
Get More
Isolated 9VDC, center-negative, 400 mA minimum,
2.1x5.5 mm barrel connector (sold separately)
STORE
Hold down to save current
settings as stored preset
PRESET LED
Lit when stored
settings are active
MOD
Adjusts the modulation
amount and/or rate
Spring 65
Wow & Flutter
Plate 140
Rate & Depth
Hall 224, Chamber & Plate 224
Chorus
EFFECT MODE
Selects variations within
the active effect
Spring 65
Bright/Smooth/Ambient
Plate 140
Plate 1/Plate 2/Plate 3
Hall 224
Room A/Small Hall A/
Large Hall B
Chamber & Plate 224
Perc Plate/Const Plate/Chamber
MIX
Adjusts the
dry/wet balance
PREDELAY
Adjusts the time
before reverb onset
PRESET SWITCH
Press to toggle effect
on/off with stored settings
ON LED
Lit when knob
settings are active
BASS
Spring 65, Plate 140
Low frequency response
Hall 224, Chamber & Plate 224
Low frequency decay
TREBLE
Spring 65, Plate 140
High frequency response
Hall 224, Chamber & Plate 224
High frequency decay
EFFECT TYPE
Push up or down to cycle
through reverb types
DECAY
Adjusts the
reverb tail time
ON SWITCH
Press to toggle effect
on/off with knob settings
MONO OUT
Connect TS cable to amp or
other gear for mono operation
STEREO OUT
Connect TS cable for stereo only
(in addition to MONO output)
9VDC POWER IN
Connect 400 mA isolated power
supply (sold separately)
MONO IN
Connect TS cable from guitar or
other gear for mono operation
USB TYPE-C
Connect to computer
for firmware updates
STEREO IN
Connect TS cable for stereo only
(in addition to MONO input)
Immersed in the light, you search for a guide. Golden emerges with the
touchstones to illuminate your journey. Here shine the quintessential
emulations of the finest reverbs ever created. The tube-driven springs of a
1960's guitar amplifier, the nostalgic warmth of studio plates, the endless
algorithmic wonder of early digital reverb. Here you remain, forever Golden.

www.uaudio.com
Caution: To help maintain the safety of your product, the chosen power supply must be a certified power supply complying with
Limited Power Source (LPS) requirements with the following characteristics and electrical ratings: Isolated 9VDC, center-negative,
400 mA minimum, 2.1x5.5 mm barrel connector. Additional details at help.uaudio.com.
Before using this unit, be sure to carefully read the applicable items of these operating instructions and the safety suggestions.
Afterwards, keep them handy for future reference. Take special care to follow the warnings indicated on the unit, as well as in the
operating instructions.
• Read the instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat source such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than
the other.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
• Only use with attachments/accessories specified by the manufacturer.
• Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.
• Golden Reverberator does not contain a fuse or any other user-replaceable parts.
• A compliance marking label is provided on bottom of the unit.
Uniited States Class B Manual Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Japanese Class B Manual Statement
この装置は、クラスＢ機器です。この装置は、住宅環境で使用することを目的としています
が、この装置がラジオやテレビジョン受信機に近接して使用されると、受信障害を引き起こ
すことがあります。取扱説明書に従って正しい取り扱いをして下さい。VCCI-B
This is Class B equipment. Although this equipment is intended for use in residential environment, it could cause poor reception
if used near a radio television receiver. Please follow instructions in the instruction manual.
Korea KCC: 해당 무선설비는 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다.
License exempt. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Used electrical and electronic equipment should not be mixed with general household waste. Please dispose in accordance with
local regulations.
•IEC 62368-1
• FCC ID: 2AXKQ2029
• IC ID: 26610-2029
Important Safety Information