Universal Audio Starlight Echo Station User manual

User Guide
v210203b

“FCC ID: 2AXKQ2029” and “IC ID: 26610-2029“
1/MONO 9VDC
USB
2/STEREO 2/STEREO
PAIR
IN
1/MONO
DELAY FEEDBACK MIX
DIVISION COLOR MOD
TAPE EP-III
ANALOG DMM
PRECISION
A
B
C
ON TAP TEMPO | PRESET
STORE
STORE
Hold down to save current
settings as stored preset
TEMPO LED
Blinks RED with quarter note
tempo, blinks GREEN when
stored preset is active
MOD
Adjusts the modulation
amount and/or rate
Tape EP-III
Wow & Flutter
Analog DMM
Depth
Precision
Rate, Depth, Feedback, Mix
Cooper Time Cube
Bass
EFFECT MODE
Selects variations within
the active effect
Tape EP-III: Machine model
and tape age
Minty Clean/Used Warm/Dark Worn
Analog DMM: Modulation
Vibrato/Off/Chorus
Precision: Modulation
Flanger/Off/Chorus
Cooper Time Cube: Filter
Off/Mid/Hi
MIX
Adjusts the
dry/wet balance
COLOR
Adjusts the delay character
Tape EP-III
Record Level
Analog DMM
Input Gain
Precision
Tone
Cooper Time Cube
Treble
FEEDBACK
Adjusts the number of repeats
TAP TEMPO | PRESET
Tap to set tempo.
Hold for 1.5s then release to
toggle stored preset on/off.
ON LED
Lit when effect is active unless
stored preset is recalled
DIVISION
Adjusts the delay time’s
quarter note tempo ratio
EFFECT TYPE
Push up or down to cycle
through delay types
DELAY
Adjusts the echo time
ON SWITCH
Press to toggle effect on/off
MONO OUT
Connect TS cable to amp or
other gear for mono operation
STEREO OUT
Connect TS cable for stereo only
(in addition to MONO output)
9VDC POWER IN
Connect 400 mA isolated power
supply (sold separately)
MONO IN
Connect TS cable from guitar or
other gear for mono operation
USB TYPE-C
Connect to computer
for firmware updates
STEREO IN
Connect TS cable for stereo only
(in addition to MONO input)
You are e mba rki ng on a p ath th at few ha ve tra vel led be fore . T han kfu lly,
the echo commanders of yore left us the sonic signposts, faithfully and
maniacally emulated herein. From the definitive tape echo, to syrupy
bucket-brigade repeats, to hi-fidelity studio delays, Starlight Echo Station
is your starting point — from here to the never-ending beyond.
Get More Free Cooper Time Cube delay effect, full documentation,
and help: uaudio.com/guitar/start
Power Supply Isolated 9VDC, center-negative, 400 mA minimum,
2.1x5.5 mm barrel connector (sold separately)

www.uaudio.com
Caution: To help maintain the safety of your product, the chosen power supply must be a certified power supply complying with
Limited Power Source (LPS) requirements with the following characteristics and electrical ratings: Isolated 9VDC, center-negative,
400 mA minimum, 2.1x5.5 mm barrel connector. Additional details at help.uaudio.com.
Before using this unit, be sure to carefully read the applicable items of these operating instructions and the safety suggestions.
Afterwards, keep them handy for future reference. Take special care to follow the warnings indicated on the unit, as well as in the
operating instructions.
• Read the instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat source such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than
the other.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
• Only use with attachments/accessories specified by the manufacturer.
• Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been dropped.
• Starlight Echo Station does not contain a fuse or any other user-replaceable parts.
• A compliance marking label is provided on bottom of the unit.
Uniited States Class B Manual Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Japanese Class B Manual Statement
この装置は、クラスＢ機器です。この装置は、住宅環境で使用することを目的としています
が、この装置がラジオやテレビジョン受信機に近接して使用されると、受信障害を引き起こ
すことがあります。取扱説明書に従って正しい取り扱いをして下さい。VCCI-B
This is Class B equipment. Although this equipment is intended for use in residential environment, it could cause poor reception
if used near a radio television receiver. Please follow instructions in the instruction manual.
Korea KCC: 해당 무선설비는 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다.
License exempt. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Used electrical and electronic equipment should not be mixed with general household waste. Please dispose in accordance with
local regulations.
•IEC 62368-1
• FCC ID: 2AXKQ2029
• IC ID: 26610-2029
Important Safety Information