10
IMPORTANT TIPS
• The Start Mist button on the
Control Panel turns Mist Cycle on
and off.
• Mister Power Switch must be
turned to ON position before Mist
Cycle can be activated (located
behind the locked Tank Access
Door).
• Mist Cycle will not activate if
Battery Charging Adapter is
plugged into Mister.
• Avoid using the Mister during
high winds (>10 mph), heavy
rainfall, fog, or when outside
air temperatures fall below 50
degrees Fahrenheit or other times
when insects are typically not
active.
ACTIVATING MIST CYCLE
WHEN TO ACTIVATE:
The ALLCLEAR Cordless Mosquito Mister PRO can be used any time of day to provide immediate and reliable control of
mosquitoes, gnats, ticks, and other biting insects*. It is recommended that users activate Mist Cycle 10 to 15 minutes
before spending time outdoors to allow for mist solution to take maximum effect (especially when mosquitoes are most
active). See ALLCLEAR Concentrate label and/or go to www.allclearmister.com for additional application instructions.
WHAT TO EXPECT:
The ALLCLEAR Cordless Mosquito Mister PRO kills and repels mosquitoes and other biting insects with an ultra-ne
mist solution of water and ALLCLEAR Mosquito Mister Concentrate. The mist solution is atomized out from Mister and
carried by the wind into desired coverage area. The atomized mist appears like a light fog and is visible for the rst 5-10
feet from the machine during the 3-minute Mist Cycle. Even when no longer visible, mist continues to move throughout
coverage area to kill and repel mosquitoes and creates an invisible barrier from insects for hours. Users will experience
immediate relief from biting insects. Best results are realized 10-15 minutes after misting. In areas of high mosquito
populations or when there are a lot of people occupying an area, a second mist application may be necessary.
Depending on weather and wind conditions, mist may swirl high and low around Mister and/or it may move directly
out from unit or drift behind Mister during Mist Cycle. This is normal operation. If mist moves toward an undesired
area, stop Mist Cycle with Remote Control, allow mist to dissipate, and reposition Mister so mist is carried by wind into
desired area. (See Page 9.)
ACTIVATING WITH REMOTE CONTROL
1. Turn Mister Power Switch to ON position.
2. Before misting and during the Mist Cycle make sure no people, pets, or food items are in the mist area.
3. Press the ON button on the Remote Control device for one second
4. After depressing ON button, there is a 12 second delay accompanied by an audible warning beep from the Mister
before the Mist Cycle begins.
5. From a location outside the misting area, watch mist movement to ensure mist moves toward desired area.
6. If mist moves toward an undesired area (e.g., bodies of water, neighboring properties, etc.), stop Mist Cycle by
pressing OFF once on Remote Control device. See ‘To Stop Mist Cycle’ on page 11 for more information.
7. Mist Cycle ends automatically after 3 minutes.
8. Re-enter area after mist has dissipated (usually 2-5 minutes).
9. If needed, move or reposition Mister (See ‘Positioning the Mister’ instructions on page 9).
10. Turn Main Power Switch to OFF position
CAUTION: Store Remote Control device in an area inaccessible to children.
* When used with ALLCLEAR Concentrates. Other insects include: ticks, gnats, horse ies, stable ies, deer ies, face ies and others.
