UPLIFT ACOUSTICS ACU015 User manual

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Step 1
Line up the holes of the Lower post with the holes on the base.
If they don’t line up, ip the Base over. Connect the two parts
together with two M5x8 Flathead screws.
Then apply the four Base pads to the bottom side of the Base.
Step 2
Fit the Crossbar onto the Upper post. Make sure each arm from
the Crossbar extends over the sides of the post that has the
holes. Connect the two parts together through the top of the
Crossbar using a M5x40 Long screw and a M5 Washer.
Step 3
Fit the Side caps onto each end of the Crossbar and attach us-
ing one M5x8 Buttonhead screw each.
Note: leave these screws slightly loose until Step 5
M5x8 Flathead screw (qty 2)
M5x40 Long screw (qty 3)
M5x8 Buttonhead screw (qty 2)
M5 Nut (qty 2)
Allen wrench
Flat wrench
Base pad (qty 4)
Base
Lower post Upper post Crossbar
Freestanding Acoustic Privacy Panel Holder
ACU015
Package Contents
Side cap
(qty 2)
Top cap
(qty 1)
Step 4
Follow the diagrams at the left to set the height of the frame
for the panel size.
Once the holes are aligned, insert two M5x40 Long screws
through both posts where indicated by the arrows. On the oth-
er side of the post, install an M5 Washer and an M5 Nut on the
other end of each screw. Hold the Nuts in place with the Flat
wrench and tighten the Long screws using the Allen wrench
until the upper post is secure.
40’’ panel 52’’ panel 64’’ panel 72’’ panel
To be used with -
Acoustic Privacy Panels (40’’-72’’)
M5 Washer (qty 3)

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Copyright Notice: This guide is a component of this accessory. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or
copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
AI-ACU015-1.290.014.01.0785v.A
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in
damage or personal injury.
CAUTIONS & WARNINGS
!
!
Step 5
Depending on ceiling height, you may need to tip the frame as-
sembly on its side for this step.
When the frame height is set, slide one of the panels into one
side of the frame through the Side caps and bottom of Lower
post as shown. Once the rst panel is in place, push the Side
caps up against the edges of the panel and tighten the two
screws from Step 3.
Then install the second panel in the same way as the rst panel,
but on the opposite side of the frame.
Finally, align the Top cap with the center of the tops of the pan-
els and press into place so it is ush with the tops of the panels.
This will keep the panels parallel and keep them from bowing
over time.