Upper Bounce UBES104 User manual

®
Upper Bounce Inc. 2 Mill St. Cornwall NY 12518, 1-888-965-3331, www.upperbounce.com
Assembly, Installation, Care, Maintenance and Use Instructions.
Upper Bounce
Enclosure Set
and Enclosure Net
User Manual
This Instructions manual is for Upper Bounce Enclosure Sets and
Enclosure Nets which is designed to fit most model Trampolines.
For Models begins with UBES: for Inside type Enclosure Sets
For Models begins with UBESOS: for Outside Type Enclosure Sets
For Models begins with UBNET: for Enclosure Nets Only

TABLE OF CONTENTS
CUSTOMER SERVICE NUMBER
1-888-965-3331
THANK YOU FOR PURCHASING THE TRAMPOLINE PART
®
UPPER BOUNCE
Simply follow the assembly and safety instructions in this manual and you will soon be starting your
®
UPPER BOUNCE exercise program and fun and be on your way to a happier, healthier lifestyle.
Should you have any questions, please call our Customer Service Department
Toll-free number: 1-888-965-3331
MONDAY - THURSDAY
9:30 A.M. - 5:00 P.M.
Eastern Time.
FRIDAY
9:00 A.M. - 12:00 P.M.
Eastern Time.
Page
Measuring Tips For Enclosure Set 3
Measuring Tips For Enclosure Net 4
Enclosure Set Package Contents 5
Pole Assembly 6
Inside type Enclosure Net Assembly 8
Outside type Enclosure Net Assembly 9
Arch type Net Enclosure Net Assembly 10
Ring on top Enclosure Net Assembly 11
Warnings 13
[e-mail]
Email us
www.upperbounce.com
Call us
Check out our website

Before you are ready to start installing your new Enclosure Set, please verify that the enclosure set
you are going to install matches the trampoline size you have.
Thank you for choosing Upper Bounce for your trampoline and trampoline replacement needs!
When you select Upper Bounce®, you are choosing high quality trampolines, or replacement parts
and accessories.At Upper Bounce® we think about "fun and safety" for the whole family!
3
1
2
3 4
5
6
78
1
2
3
4
1
2
3
4
1
2
3
4
Fig. 1
These are the steps to make sure you purchased the right Enclosure Set:
Count the legs. The amount of W shaped
legs you have that's the amount of poles
you will need.
or connect 2 poles to each leg as shown in
figure 2.
Fig. 2
Measure your frame from one outside edge vertically and horizontally to the other
outside edge so you get the correct measurements.
1FT
1FT 2FT 3FT 4FT 5FT 6FT 7FT 8FT 9FT 10FT 11FT 12FT 13FT
14 FT
14 FT
14FT
For example - if your legs count is 6 W shaped legs you need 6 poles. If it counts 4 legs you can either
take 4 poles for every second leg (Fig. 1) or 8 poles (Fig. 2).
FRAME SIZE
STEP 1
POLE AMOUNT
STEP 2
Measuring Tips For Enclosure Set

4
Check the diameter of the leg to make
sure the pole connecting tool fits your
Trampoline, If the Pole diameter is 1 inch
you need to look for a 1 inch connecter if
its 1 ½ you need a 1 ½ connecter.
1 1/2
1 1/2
Note: You can also connect the poles to the leg
with U shape connecter Model UBHWD-UB-12
for set of 12 and model UBHWD-UB-16 for set
of 15.
STEP 3POLE CONNECTOR
Determine if you bought the correct Enclosure Set
1) Frame Size 2) Leg Amount 3) Leg Diameter
Based on the
If you purchased an enclosure net only
1. Make Sure the Net size matches the frame size (see above how to measure the frame size).
2. Make sure the poles/arch amount of the product matches the amount of your trampoline.
3. Make sure the height of the product is matching to the height of your existing poles or arches.
7.5 ft
8 ft
10 ft
12 ft and +
65"
65"
64"
71"
Height chart of all type of nets
Measuring Tips For Enclosure Net

ENCLOSURE SET PARTS LIST
ITEM PART IMAGE
A
C
D
E-1
F
B
UBES104
UBES124
UBES144
UBESOS124
UBES86, UBES126
UBES146, UBES156
UBES106, UBES136
UBES166, UBESOS7.56
UBESOS126, UBESOS136
UBESOS146, UBESOS156
UBES128,
UBES148,
UBES158,
UBES138
UBESOS138,
UBESOS148
UBESOS158
4
8
1
4
1
4
6
12
1
6
1
6
8
16
1
8
1
8
Upper Pole
Lower Pole
Clamp
Tool Set
Tool
Pole Cap
Enclosure
Net
NAME
5
QUANTITY
MODELS
For Inside Type
For Outside Type
E-2

1. First, place all parts to be used in the
process of installation in front of you.
2. Take the clamp and clasp the trampoline
pole into the smaller hole of the 8-Shaped
Pole Clamp. (serves as the pole and leg
connector),
3. Once the pole is securely inserted into the
clamp you can now clasp the leg into the
larger hole of the clamp. Making sure that
the black rubber cap of the lower pole
faces down.
4. Be aware that the mark on the lower pole
needs to align with the trampoline frame. If
there is no line on the pole then please
have it attached 18” below the frame.
6
2 adults in good physical condition are required for the following
assembly. Wear proper shoes and maintain balance to prevent a fall.
Failure to follow all instructions and warnings may result in serious
injury.
Warning :
Pole Installation Instructions
8-Shaped Pole Clamp
18 inches

2 inches
6
5. The set comes with 2 clamps per pole.
One being attached 2” below frame,
while the other being attached 2” above
the end of the lower pole.
6. Feed the screw through the screw hole
thus tightening the clamp to securely
connect it to your trampoline leg with the
tool included.
7. Now you can have the upper part of the
pole inserted into the lower part that is
already attached to the leg.
8. Repeat the steps above to have all your
enclosure poles connected securely to
your trampoline legs.
7
2 inches
9. 9. After connecting all Enclosure Poles insert the Pole caps, if you have an Inside Type Net
use part number E1 and for outside type Net use E2
E1
E1
E1
E1 E1
E1
E1
E1 E2
E2
E2 E2
E2
E2
E2E2
For inside Type Net E-1 For outside type Net E-2
After you installed the Poles you should install the Enclosure Net, for intructions how to install the
Enclosure Net see Bellow the inside type model and the outside type choose the one applies to
your purchase,

8
STEP 1POLE STRAPS
STEP 2MIDDLE STRAPS
STEP 3BOTTOM STRAPS
Connect the middle straps to center of
each pole or arch pole
Connect bottom straps/clips to every few jumping mat
v-rings from under the safety pad (lift your pad at each)
INSIDE TYPE MODELS
UBES86
UBES104
UBES124
UBES144
UBES126
UBES128
UBES146
UBES148
UBES156
UBES158
UBES106
UBES136
UBES138
UBES166
UBNET-13-8-IS
UBNET-14-4-IS
UBNET-14-6-IS
UBNET-14-8-IS
UBNET-15-6-IS
UBNET-15-8-IS
UBNET-16-6-IS
Enclosure Nets Enclosure Sets
UBNET-8-6-IS
UBNET-10-4-IS
UBNET-10-6-IS
UBNET-12-8-IS
UBNET-12-4-IS
UBNET-12-6-IS
UBNET-13-6-IS
If you Purchased a
Enclosure Set use this Step
Net Installation Instructions

OUTSIDE TYPE MODELS
Net Installation Instructions
STEP 1INSERT THE NET TO THE POLES
Pull down each sleeve, a few inches at a time till all sleeves
reach the bottom of enclosure frame as shown in figure 2.
UBNET-7.5-6-OS
UBNET-10-8-OS
UBNET-12-4-OS
UBNET-12-6-OS
UBNET-13-6-OS
UBNET-13-8-OS
UBNET-14-6-OS
UBNET-14-8-OS
UBNET-15-6-OS
UBNET-15-8-OS
UBESOS138
UBESOS146
UBESOS148
UBESOS156
UBESOS158
Enclosure Sets Enclosure Nets
UBESOS7.56
UBESOS108
UBESOS124
UBESOS126
UBESOS136
Connect bottom straps/clips to every few Jumping mat v-rings from under the Safety Pad.
Attach the clips from outside as figure shows.
STEP 2CONNECT BOTTOM STRAPS
9
Start installing the Net to the poles by inserting the beginning
of the Sleeve on the Poles Until it reaches 2 ft. and continue
doing the same to all poles as figure 1.
Fig. 1
Fig. 2

FOR ARCH TYPE MODELS
Net Installation Instructions
STEP 1INSERT THE NET TO THE ARCHES
10
Disconnect the top arches, slide top arch part into sleeve.
When arch part and poles meet click them back together tightly.
STEP 2BOTTOM STRAPS
Connect bottom straps/clips to
every few jumping mat
v-rings from under the safety pad
(lift your pad at each)
UBNET-12-2-AST
UBNET-12-3-AST
UBNET-12-4-AST
UBNET-13-2-ASTR
UBNET-13-3-AST
UBNET-13-4-AST
Enclosure Nets
UBNET-14-3-AST
UBNET-14-4-AST
UBNET-15-3-AST
UBNET-15-4-AST
1 2

FLEX ON TOP MODELS
Net Installation Instructions
STEP 1
Start by running the Fiberglass Rods
through the sleeves opening at the
upper edge of the safety net until you reach
the other side of the sleeve as figure 1.
STEP 2
After inserting the top rods through all the sleeves you need to connect all rods together, there is
several ways to connect it:
11
STEP 3
Repeat with remaining rods until everything is
connected together. To make the last connection
have one person stand on the opposite side, push
the rods towards the center of the ring until they are
in line with each other and make the last connection
as shown in picture.
1. With T pole caps as figure 1. 2. With nuts that connects it together with
Adjustable Wrench as figure 2.
21
UBNET12FG-4
UBNET-12FG-6
UBNET-14FG-4
UBNET-14FG-6
Enclosure Nets
UBNET-15FG-5
UBNET-15FGB-5
UBNET-15FG-6

STEP 4
Raise the net up into position and connect the rods to the poles with the following options:
STEP 5
Connect the bottom clips to the v rings
by hooking it up to every few v rings.
Option 1 -
If you have T connectors Insert
the T-shaped Pole Caps into the
upper poles as shown in picture.
Option 2 -
If your rod is connected in any
other way, connect the rod to
the pole cap by clicking it in
as figure shows.
12

13
1. Please ensure that the safety enclosure net zipper is 100% closed and all three entrance
hooks are re-hooked before jumping.
2. Do not intentionally jump into the safety net, it is only designed to stop persons from
falling off the trampoline. Intentional jumping into the safety net may cause the
trampoline to topple over, or may damage your net. Abuse of the safety net is considered
negligent use which is not covered by the warranty, please refer to the disclaimer.
WARNING:
!
Enclosure Net Safety Checks:
ØHold onto pole net jacket and check that all the enclosure poles are sturdy by shaking it.
ØCheck the enclosure net and pole jacket for any tearing in the stitching or material.
ØCheck the enclosure net zipper and entrance hooks function properly.
ØCheck to see if all safety enclosure hook are attached to the triangle ring under the
trampoline.
After reading this entire manual and you still have any questions or concerns ?
Dont worry Just make a phone call at 1800.965.3331 or email us to
[email protected] and we will assist you the best possible,
remember!! if you don't call us how will you know how our customer service
are resolving issues.
Happy Jumping!
Wish the Upper Bounce Team
After you are fully satisfied or for any suggestions how we can
serve you even better for next time. Please go to -
We need your feedback
www.upperbounce.com/feedback